Re: [PATCH v3] ahci_xgene: Fix the dma state machine lockup for the ATA_CMD_SMART PIO mode command.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hello.

On 02/02/2015 09:07 PM, Suman Tripathi wrote:

This patch addresses the issue with ATA_CMD_SMART pio mode
command for enumeration and device detection with ATA devices.
The X-Gene AHCI controller has an errata in which it cannot clear
the BSY bit after the PIO setup FIS. The dma state machine enters

Hum, if this happens after every PIO command (PIO setup FISes are not specific to the command, right?), perhaps it would make more sense to record the *protocol* used by the last command?

CMFatalErrorUpdate state and locks up. It is the same issue as
in the commit 2a0bdff6b958d1b2523d2754b6cd5e0ea4053016 (ahci-xgene:
fix the dma state machine lockup for the IDENTIFY DEVICE PIO mode
command).

For example :  without this patch it results in READ DMA command failure
as shown below :

[...]

Signed-off-by: Suman Tripathi <stripathi@xxxxxxx>
Reported-by:   Mark Langsdorf <mlangsdo@xxxxxxxxxx>

MBR, Sergei

--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux