This patch addresses the issue with ATA_CMD_PACKET pio mode command for enumeration and device detection with ATAPI devices.It is the same issue as in patch www.spinics.net/lists/linux-ide/msg49092.html Signed-off-by: Suman Tripathi <stripathi@xxxxxxx> --- drivers/ata/ahci_xgene.c | 12 +++++++----- 1 file changed, 7 insertions(+), 5 deletions(-) diff --git a/drivers/ata/ahci_xgene.c b/drivers/ata/ahci_xgene.c index 0ffd3c9..9730907 100644 --- a/drivers/ata/ahci_xgene.c +++ b/drivers/ata/ahci_xgene.c @@ -125,10 +125,11 @@ static int xgene_ahci_restart_engine(struct ata_port *ap) * xgene_ahci_qc_issue - Issue commands to the device * @qc: Command to issue * - * Due to Hardware errata for IDENTIFY DEVICE command, the controller cannot - * clear the BSY bit after receiving the PIO setup FIS. This results in the dma - * state machine goes into the CMFatalErrorUpdate state and locks up. By - * restarting the dma engine, it removes the controller out of lock up state. + * Due to Hardware errata for IDENTIFY DEVICE command and COMMAND PACKET + * command of ATAPI protocol set, the controller cannot clear the BSY bit + * after receiving the PIO setup FIS. This results in the dma state machine + * goes into the CMFatalErrorUpdate state and locks up. By restarting the + * dma engine, it removes the controller out of lock up state. */ static unsigned int xgene_ahci_qc_issue(struct ata_queued_cmd *qc) { @@ -137,7 +138,8 @@ static unsigned int xgene_ahci_qc_issue(struct ata_queued_cmd *qc) struct xgene_ahci_context *ctx = hpriv->plat_data; int rc = 0; - if (unlikely(ctx->last_cmd[ap->port_no] == ATA_CMD_ID_ATA)) + if (unlikely((ctx->last_cmd[ap->port_no] == ATA_CMD_ID_ATA) || + (ctx->last_cmd[ap->port_no] == ATA_CMD_PACKET))) xgene_ahci_restart_engine(ap); rc = ahci_qc_issue(qc); -- 1.8.2.1 -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html