On 06/16/2014 12:26 PM, Antoine Ténart wrote:
The BG2Q has an AHCI SATA controller. Add the corresponding nodes
(AHCI, PHY) into its device tree.
Signed-off-by: Antoine Ténart <antoine.tenart@xxxxxxxxxxxxxxxxxx>
---
arch/arm/boot/dts/berlin2q.dtsi | 28 ++++++++++++++++++++++++++++
1 file changed, 28 insertions(+)
diff --git a/arch/arm/boot/dts/berlin2q.dtsi b/arch/arm/boot/dts/berlin2q.dtsi
index 635a16a64cb4..3fb0d3935aec 100644
--- a/arch/arm/boot/dts/berlin2q.dtsi
+++ b/arch/arm/boot/dts/berlin2q.dtsi
@@ -303,6 +303,34 @@
clock-names = "refclk";
};
+ ahci: sata@e90000 {
+ compatible = "generic-ahci";
+ reg = <0xe90000 0x1000>;
+ interrupts = <GIC_SPI 7 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&chip CLKID_SATA>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ sata0: sata-port@0 {
+ reg = <0>;
+ phys = <&sata_phy 0>;
+ status = "disabled";
+ };
+
+ sata1: sata-port@1 {
+ reg = <1>;
+ phys = <&sata_phy 1>;
+ status = "disabled";
+ };
+ };
+
+ sata_phy: phy@e900a0 {
+ compatible = "marvell,berlin-sata-phy";
+ reg = <0xe900a0 0x200>;
Antoine,
I guess you'll also need
clocks = <&chip CLKID_SATA>;
here and corresponding code in the PHY driver.
If SATA PHY is accessing SATA registers, disabling the clock will
most likely lock-up the SoC.
Sebastian
+ #phy-cells = <1>;
+ status = "disabled";
+ };
+
apb@fc0000 {
compatible = "simple-bus";
#address-cells = <1>;
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
