On 12/03/2012 04:08 PM, Chris Friesen wrote:
On 12/03/2012 02:52 PM, Ric Wheeler wrote:
I jumped into this thread late - can you repost detail on the specific
drive and HBA used here? In any case, it sounds like this is a better
topic for the linux-scsi or linux-ide list where most of the low level
storage people lurk :)
Okay, expanding the receiver list. :)
To recap:
I'm running 2.6.27 with LVM over software RAID 1 over a pair of SAS disks.
Disks are WD9001BKHG, controller is Intel C600.
Recently we started seeing messages of the following pattern, and we
don't know what's causing them:
Nov 28 08:57:10 kernel: end_request: I/O error, dev sda, sector 1758169523
Nov 28 08:57:10 kernel: md: super_written gets error=-5, uptodate=0
Nov 28 08:57:10 kernel: raid1: Disk failure on sda2, disabling device.
Nov 28 08:57:10 kernel: raid1: Operation continuing on 1 devices.
We've been assuming it's a software issue since it's reproducible on
multiple systems, although so far we've only seen the problem with
these particular disks.
We've seen the problems with disk write cache enabled and disabled.
Hi Chris,
Are there any earlier IO errors or sda related errors in the log?
Ric
It looks like it may be related to being in the middle of a background
short self-test at the time we see the error. The disks are still
in-service at this point--is this supported behaviour or would it
be expected to cause errors? (The self-test works fine with other
disks, and worked fine with these disks until recently, but we haven't
made any changes to the block I/O code.)
Here's the smartctl output from right after a failure. The self-tests
are frequent as a stress-test, normally they're done once per day:
root@typhoon-base-unit0:/root> ./smartctl --all /dev/sda
smartctl version 5.38 [i686-wrs-linux-gnu] Copyright (C) 2002-8 Bruce Allen
Home page is http://smartmontools.sourceforge.net/
Device: WD WD9001BKHG-02D22 Version: SR03
Serial number: WX21EB1ANU78
Device type: disk
Transport protocol: SAS
Local Time is: Fri Nov 23 00:35:03 2012 HKT
Device supports SMART and is Enabled
Temperature Warning Enabled
SMART Health Status: OK
Current Drive Temperature: 39 C
Drive Trip Temperature: 69 C
Manufactured in week 01 of year 2010
Recommended maximum start stop count: 1048576 times
Current start stop count: 26 times
Elements in grown defect list: 0
Error counter log:
Errors Corrected by Total Correction Gigabytes Total
ECC rereads/ errors algorithm processed uncorrected
fast | delayed rewrites corrected invocations [109 bytes] errors
read: 21187 2 2 21189 2 4950.446 0
write: 89 4 0 93 4 1317.938 0
verify: 103 0 0 103 0 0.000 0
Non-medium error count: 169436
SMART Self-test log
Num Test Status segment LifeTime LBA_first_err [SK ASC ASQ]
Description number (hours)
# 1 Background short Self test in progress ... 4 NOW - [- - -]
# 2 Background short Completed - 1377 - [- - -]
# 3 Background short Completed - 1377 - [- - -]
# 4 Background short Completed - 1377 - [- - -]
# 5 Background short Completed - 1377 - [- - -]
# 6 Background short Completed - 1377 - [- - -]
# 7 Background short Completed - 1377 - [- - -]
# 8 Background short Completed - 1377 - [- - -]
# 9 Background short Completed - 1377 - [- - -]
#10 Background short Completed - 1377 - [- - -]
#11 Background short Completed - 1377 - [- - -]
#12 Background short Completed - 1377 - [- - -]
#13 Background short Completed - 1377 - [- - -]
#14 Background short Completed - 1377 - [- - -]
#15 Background short Completed - 1377 - [- - -]
#16 Background short Completed - 1377 - [- - -]
#17 Background short Completed - 1377 - [- - -]
#18 Background short Completed - 1377 - [- - -]
#19 Background short Completed - 1377 - [- - -]
#20 Background short Completed - 1377 - [- - -]
Long (extended) Self Test duration: 6362 seconds [106.0 minutes]
I also have this from ten minutes later with a newer version of smartctl:
root@typhoon-base-unit0:/root> ./smartctl.eric -x /dev/sda
smartctl 5.40 2010-10-16 r3189 [i686-pc-linux-gnu] (local build)
Copyright (C) 2002-10 by Bruce Allen, http://smartmontools.sourceforge.net
Device: WD WD9001BKHG-02D22 Version: SR03
Serial number: WX21EB1ANU78
Device type: disk
Transport protocol: SAS
Local Time is: Fri Nov 23 00:45:08 2012 HKT
Device supports SMART and is Enabled
Temperature Warning Enabled
SMART Health Status: OK
Current Drive Temperature: 39 C
Drive Trip Temperature: 69 C
Manufactured in week 01 of year 2010
Specified cycle count over device lifetime: 1048576
Accumulated start-stop cycles: 26
Specified load-unload count over device lifetime: 1114112
Accumulated load-unload cycles: 0
Elements in grown defect list: 0
Error counter log:
Errors Corrected by Total Correction Gigabytes Total
ECC rereads/ errors algorithm processed uncorrected
fast | delayed rewrites corrected invocations [109 bytes] errors
read: 21189 2 2 21191 2 4950.446 0
write: 89 4 0 93 4 1317.939 0
verify: 103 0 0 103 0 0.000 0
Non-medium error count: 169436
SMART Self-test log
Num Test Status segment LifeTime LBA_first_err [SK ASC ASQ]
Description number (hours)
# 1 Background short Completed - 1378 - [- - -]
# 2 Background short Completed - 1378 - [- - -]
# 3 Background short Completed - 1378 - [- - -]
# 4 Background short Completed - 1377 - [- - -]
# 5 Background short Completed - 1377 - [- - -]
# 6 Background short Completed - 1377 - [- - -]
# 7 Background short Completed - 1377 - [- - -]
# 8 Background short Completed - 1377 - [- - -]
# 9 Background short Completed - 1377 - [- - -]
#10 Background short Completed - 1377 - [- - -]
#11 Background short Completed - 1377 - [- - -]
#12 Background short Completed - 1377 - [- - -]
#13 Background short Completed - 1377 - [- - -]
#14 Background short Completed - 1377 - [- - -]
#15 Background short Completed - 1377 - [- - -]
#16 Background short Completed - 1377 - [- - -]
#17 Background short Completed - 1377 - [- - -]
#18 Background short Completed - 1377 - [- - -]
#19 Background short Completed - 1377 - [- - -]
#20 Background short Completed - 1377 - [- - -]
Long (extended) Self Test duration: 6362 seconds [106.0 minutes]
Background scan results log
Status: no scans active
Accumulated power on time, hours:minutes 1378:08 [82688 minutes]
Number of background scans performed: 0, scan progress: 0.00%
Number of background medium scans performed: 0
Protocol Specific port log page for SAS SSP
relative target port id = 1
generation code = 0
number of phys = 1
phy identifier = 0
attached device type: end device
attached reason: unknown
reason: unknown
negotiated logical link rate: phy enabled; 3 Gbps
attached initiator port: ssp=1 stp=1 smp=1
attached target port: ssp=0 stp=0 smp=0
SAS address = 0x50014ee3556977a6
attached SAS address = 0x5fcfffff00000001
attached phy identifier = 0
Invalid DWORD count = 0
Running disparity error count = 0
Loss of DWORD synchronization = 3
Phy reset problem = 0
Phy event descriptors:
Transmitted SSP frame error count: 0
Received SSP frame error count: 0
relative target port id = 2
generation code = 0
number of phys = 1
phy identifier = 1
attached device type: no device attached
attached reason: unknown
reason: unknown
negotiated logical link rate: phy enabled; unknown
attached initiator port: ssp=0 stp=0 smp=0
attached target port: ssp=0 stp=0 smp=0
SAS address = 0x50014ee3556977a7
attached SAS address = 0x0
attached phy identifier = 0
Invalid DWORD count = 0
Running disparity error count = 0
Loss of DWORD synchronization = 0
Phy reset problem = 0
Phy event descriptors:
Transmitted SSP frame error count: 0
Received SSP frame error count: 0
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html