Hello, Recent kernels broke suspend/hibernate completely on one of my setups after updating to more recent kernels (3.3). It used to work perfectly and the machine was hardly ever powered completely off (standby). (older M2N-E ASUS motherboard with nvidia MC55 controller). The symptoms where that the system would hang entering hibernate. The only complaint from the system was that command STANDBY_IMMEDIATE had failed. At first i assumed that the disk (an older WD Green disk) was dying, and replaced the disk with a cheap Seagate disk. However, this turned out not to be the case. Looking through the ATA code i found that STANDBY had been replaced with STANDBY_IMMEDIATE as it was supposed to be more compliant. Replacing it with the old STANDBY made the standby procedure work again. Now the question is: The STANDBY and STANDBY_IMMEDIATE commands are for the disk. Why does it specifically break for disks on MCP55 and not on other chipsets? Does it make sense? FWIW both disks seem to suspend fine on the same controller using an other O/S. Later i also discovered that the new disk actually made things worse. Using the hack suspend worked again for the old disk. The new disk could now suspend but would mostly get stuck getting out of suspend as it would seem that the system caused it to stop responding all together requiring a hard reboot. Any ideas? Thanks, /pedro -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html