I've got a parisc system where the DVD drive is hardwired to a silicon image controller: 00:02.0 IDE interface: Silicon Image, Inc. SiI 0649 Ultra ATA/100 PCI to ATA Host Controller (rev 02) (prog-if 8f [Master SecP SecO PriP PriO]) Subsystem: Silicon Image, Inc. SiI 0649 Ultra ATA/100 PCI to ATA Host Controller Flags: bus master, medium devsel, latency 64, IRQ 69 I/O ports at 0d18 [size=8] I/O ports at 0d24 [size=4] I/O ports at 0d10 [size=8] I/O ports at 0d20 [size=4] I/O ports at 0d00 [size=16] Capabilities: [60] Power Management version 2 Kernel driver in use: pata_cmd64x The specific problem is that any access to the registers where the secondary port should be causes an instant fault on the box (I think because the second port just isn't wired up internally, so the memory doesn't respond), so the default libata-sff driver that pata_cmd64x is attached to causes this by insisting on probing both ports. I can get all of this working by fixing up all the hard coded knowledge in libata-sff only to use a single port. However, I can't fix the libata-sff driver until I know how to tell there's only one port wired. Does anyone with cmd649 knowledge have any idea how I might tell this? James -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html