[PATCH] sata_mv: enable ATAPI DMA for GEN_IIE chips

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Enable ATAPI DMA transfers on GEN_IIE chips (6042/7042/SOC).
This also gets rid of any need for mv_mode_filter().

Signed-off-by: Mark Lord <mlord@xxxxxxxxx>

--- old/drivers/ata/sata_mv.c	2009-02-03 14:58:13.000000000 -0500
+++ linux/drivers/ata/sata_mv.c	2009-02-04 12:58:52.000000000 -0500
@@ -345,7 +345,7 @@
	EDMA_ARB_CFG_OFS	= 0x38,

	EDMA_HALTCOND_OFS	= 0x60,		/* GenIIe halt conditions */
-
+	EDMA_UNKNOWN_RSVD_OFS	= 0x6C,		/* GenIIe unknown/reserved */

	BMDMA_CMD_OFS		= 0x224,	/* bmdma command register */
	BMDMA_STATUS_OFS	= 0x228,	/* bmdma status register */
@@ -551,8 +551,6 @@
static void mv_process_crpb_entries(struct ata_port *ap,
					struct mv_port_priv *pp);

-static unsigned long mv_mode_filter(struct ata_device *dev,
-				    unsigned long xfer_mask);
static void mv_sff_irq_clear(struct ata_port *ap);
static int mv_check_atapi_dma(struct ata_queued_cmd *qc);
static void mv_bmdma_setup(struct ata_queued_cmd *qc);
@@ -614,7 +612,6 @@
	.bmdma_start		= mv_bmdma_start,
	.bmdma_stop		= mv_bmdma_stop,
	.bmdma_status		= mv_bmdma_status,
-	.mode_filter		= mv_mode_filter,
};

static struct ata_port_operations mv_iie_ops = {
@@ -1260,6 +1257,25 @@
	writelfl(cfg, port_mmio + EDMA_CFG_OFS);
}

+/**
+ * 	mv_bmdma_enable - set a magic bit on GEN_IIE to allow bmdma
+ * 	@ap: Port being initialized
+ */
+static void mv_bmdma_enable(struct ata_port *ap)
+{
+	struct mv_host_priv *hpriv = ap->host->private_data;
+
+	if (IS_GEN_IIE(hpriv)) {
+		void __iomem *port_mmio = mv_ap_base(ap);
+		/*
+		 * Some magic is required to get non-EDMA DMA to work:
+		 */
+		u32 rsvd = readl(port_mmio + EDMA_UNKNOWN_RSVD_OFS);
+		if (!(rsvd & 1))
+			writel(rsvd | 1, port_mmio + EDMA_UNKNOWN_RSVD_OFS);
+	}
+}
+
static void mv_port_free_dma_mem(struct ata_port *ap)
{
	struct mv_host_priv *hpriv = ap->host->private_data;
@@ -1340,6 +1356,7 @@
		}
	}
	mv_edma_cfg(ap, 0, 0);
+	mv_bmdma_enable(ap);
	return 0;

out_port_free_dma_mem:
@@ -1417,26 +1434,6 @@
}

/**
- *	mv_mode_filter - Allow ATAPI DMA only on GenII chips.
- *	@dev: device whose xfer modes are being configured.
- *
- *	Only the GenII hardware can use DMA with ATAPI drives.
- */
-static unsigned long mv_mode_filter(struct ata_device *adev,
-				    unsigned long xfer_mask)
-{
-	if (adev->class == ATA_DEV_ATAPI) {
-		struct mv_host_priv *hpriv = adev->link->ap->host->private_data;
-		if (!IS_GEN_II(hpriv)) {
-			xfer_mask &= ~(ATA_MASK_MWDMA | ATA_MASK_UDMA);
-			ata_dev_printk(adev, KERN_INFO,
-				"ATAPI DMA not supported on this chipset\n");
-		}
-	}
-	return xfer_mask;
-}
-
-/**
 *	mv_sff_irq_clear - Clear hardware interrupt after DMA.
 *	@ap: Port associated with this ATA transaction.
 *
@@ -2997,7 +2994,7 @@
		}
	} while (sstatus != 0x0 && sstatus != 0x113 && sstatus != 0x123);
	mv_edma_cfg(ap, 0, 0);
-
+	mv_bmdma_enable(ap);
	return rc;
}

--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux