Hello, I wrote:
Thats wrong -- According t the spec. the bit should be set following
any assertion of INTRQ on IDE bus (possibly not at once though --
after flushing FIFO). Well, no wonder with such description of the
bits as:
INT_IDE (RWC) [Interrupt]
Is “1” when data transfer completes. This bit is cleared by writing
“1” to it.
When this bit is set to ‘1’, the following bits of the ATA Interrupt
Controller Register will be
reset: bits [15:8] (Mask Address Error INT, Mask Reach Multiple INT,
Mask DEV
Timing Error, Mask Ultra DMA DEV Terminate, Mask Timer INT, Mask Bus
Error, Mask
Data Transfer End, Mask Host INT), and bits [1:0] (Data Transfer End,
Host INT).
Forgot to mentiom that from this description it's not even clear if
the int_ctl register bits are cleared when 1 is written to this bit or
when the controller sets it. :-)
MBR, Sergei
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
