http://bugzilla.kernel.org/show_bug.cgi?id=11576 Summary: compactflash TRANSCEND at ide adapter failed to IDENTIFY Product: IO/Storage Version: 2.5 KernelVersion: 2.6.24-19-generic 64bit (gcc version 4.2.3) #1 SMP Wed Aug 20 17 Platform: All OS/Version: Linux Tree: Mainline Status: NEW Severity: normal Priority: P1 Component: IDE AssignedTo: io_ide@xxxxxxxxxxxxxxxxxxxx ReportedBy: werner.hein@xxxxxxx Latest working kernel version: n/a Earliest failing kernel version: no idea but short tests failed on Ubuntu 6.06.1 & 7.10 Distribution: Kubuntu 8.04.1 Hardy Heron Hardware Environment: Intel D945GCLF + AtomCPU, CF TRANSCEND TS4GCF120 at CF->IDE adapter via 80 wire cable to single pata/ide port, CF is master and only device connected to pata/ide, SAMSUNG 750GB at sata, 2GB DDR2 ram Software Environment: Kubuntu 8.04.1 Desktop, basic installation Problem Description: CF fails during boot, partition table cannot be read, no access to CF sequence of failure: libata - detects at ata1.00 CF including name and size correctly - configures IF for MWDMA2 - assignes IF to scsi - goes on with sata [] ata1: PATA max UDMA/100 cmd 0x1f0 ctl 0x3f6 bmdma 0x2090 irq 14 [] ata2: PATA max UDMA/100 cmd 0x170 ctl 0x376 bmdma 0x2098 irq 15 [] ata1.00: ATA-0: TRANSCEND, 20070312, max MWDMA2 [] ata1.00: 8077104 sectors, multi 0: LBA [] ata1.00: configured for MWDMA2 [] ata1.00: configured for MWDMA2 [] ata1: EH complete [] ata2: port disabled. ignoring. [] scsi 0:0:0:0: Direct-Access ATA TRANSCEND 2007 PQ: 0 ANSI: 5 sd - driver takes over and starts with CF as sda - still starting with correct parameters - then timeout upon a command + error messages "failed to IDENTIFY" and "revalidation failed" [] Driver 'sd' needs updating - please use bus_type methods [] sd 0:0:0:0: [sda] 8077104 512-byte hardware sectors (4135 MB) [] sd 0:0:0:0: [sda] Write Protect is off [] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00 [] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA [] sd 0:0:0:0: [sda] 8077104 512-byte hardware sectors (4135 MB) [] sd 0:0:0:0: [sda] Write Protect is off [] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00 [] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA [] sda:<3>ata1.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x2 frozen [] ata1.00: cmd c8/00:08:00:00:00/00:00:00:00:00/e0 tag 0 dma 4096 in [] res 40/00:00:00:00:00/00:00:00:00:00/00 Emask 0x4 (timeout) [] ata1.00: status: { DRDY } [] ata1: soft resetting link [] ata1.00: failed to IDENTIFY (INIT_DEV_PARAMS failed, err_mask=0x80) [] ata1.00: revalidation failed (errno=-5) [] ata1: failed to recover some devices, retrying in 5 secs [] ata1: soft resetting link ... <repetitions> ... - later on followed by some more error messages [] sd 0:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET driverbyte=DRIVER_OK,SUGGEST_OK [] end_request: I/O error, dev sda, sector 0 [] Buffer I/O error on device sda, logical block 0 [] sd 0:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET driverbyte=DRIVER_OK,SUGGEST_OK [] end_request: I/O error, dev sda, sector 0 [] Buffer I/O error on device sda, logical block 0 [] sd 0:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET driverbyte=DRIVER_OK,SUGGEST_OK [] end_request: I/O error, dev sda, sector 0 [] Buffer I/O error on device sda, logical block 0 ... <repetitions> ... sudo hdparm -I /dev/sda /dev/sda: HDIO_DRIVE_CMD(identify) failed: Input/output error needless to say that CF has been checked in a CF card reader on same board's usb and works perfectly there Steps to reproduce: - failure comes every time -- Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug, or are watching the assignee. -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
