Re: [PATCH] ahci: enable GHC.AE bit before set GHC.HR

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, 21 Sep 2007 12:31:20 +0200
Jens Axboe <jens.axboe@xxxxxxxxxx> wrote:

> On Fri, Sep 21 2007, Peer Chen wrote:
> > According to the description of section 5.2.2.1 and 10.1.2 of AHCI specification rev1_1/rev1_2, GHC.HR shall only be set to ¡®1¡¯
> > by software when GHC.AE is set to ¡®1¡¯.
> > 
> > Signed-off-by: Peer Chen <peerchen@xxxxxxxxx>
> > ---
> > --- linux-2.6.23-rc7/drivers/ata/ahci.c.orig	2007-09-20 11:01:55.000000000 -0400
> > +++ linux-2.6.23-rc7/drivers/ata/ahci.c	2007-09-20 11:07:31.000000000 -0400
> > @@ -834,6 +834,10 @@ static int ahci_reset_controller(struct 
> >  	void __iomem *mmio = host->iomap[AHCI_PCI_BAR];
> >  	u32 tmp;
> >  
> > +        /* turn on AHCI mode before controller reset*/
> > +        writel(HOST_AHCI_EN, mmio + HOST_CTL);
> > +        (void) readl(mmio + HOST_CTL);  /* flush */
> > +
> >  	/* global controller reset */
> >  	tmp = readl(mmio + HOST_CTL);
> >  	if ((tmp & HOST_RESET) == 0) {
> 
> I appreciate the readl() flushes, but in this particular case we end up
> reading the exact offset again below.

The code above is wrong btw - it is an iomap so both the new and existing
code should be using ioread* not readl

Alan
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux