Currently the PCI glue driver uses sda_hold variable name, while the rest of the driver use sda_hold_time. This makes things harder to grep. Use sda_hold_time variable name everywhere. Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> --- drivers/i2c/busses/i2c-designware-pcidrv.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/drivers/i2c/busses/i2c-designware-pcidrv.c b/drivers/i2c/busses/i2c-designware-pcidrv.c index 433cb285d3b2..38265c3dc454 100644 --- a/drivers/i2c/busses/i2c-designware-pcidrv.c +++ b/drivers/i2c/busses/i2c-designware-pcidrv.c @@ -51,7 +51,7 @@ struct dw_scl_sda_cfg { u16 fs_hcnt; u16 ss_lcnt; u16 fs_lcnt; - u32 sda_hold; + u32 sda_hold_time; }; struct dw_pci_controller { @@ -76,7 +76,7 @@ static struct dw_scl_sda_cfg byt_config = { .fs_hcnt = 0x55, .ss_lcnt = 0x200, .fs_lcnt = 0x99, - .sda_hold = 0x6, + .sda_hold_time = 0x6, }; /* Haswell HCNT/LCNT/SDA hold time */ @@ -85,14 +85,14 @@ static struct dw_scl_sda_cfg hsw_config = { .fs_hcnt = 0x48, .ss_lcnt = 0x01fb, .fs_lcnt = 0xa0, - .sda_hold = 0x9, + .sda_hold_time = 0x9, }; /* NAVI-AMD HCNT/LCNT/SDA hold time */ static struct dw_scl_sda_cfg navi_amd_config = { .ss_hcnt = 0x1ae, .ss_lcnt = 0x23a, - .sda_hold = 0x9, + .sda_hold_time = 0x9, }; static u32 mfld_get_clk_rate_khz(struct dw_i2c_dev *dev) @@ -264,7 +264,7 @@ static int i2c_dw_pci_probe(struct pci_dev *pdev, dev->fs_hcnt = cfg->fs_hcnt; dev->ss_lcnt = cfg->ss_lcnt; dev->fs_lcnt = cfg->fs_lcnt; - dev->sda_hold_time = cfg->sda_hold; + dev->sda_hold_time = cfg->sda_hold_time; } adap = &dev->adapter; -- 2.43.0.rc1.1336.g36b5255a03ac