Hi,
On Wed, Sep 11, 2024 at 12:28 AM Chen-Yu Tsai <wenst@xxxxxxxxxxxx> wrote:
>
> +static int i2c_of_probe_simple_enable_regulator(struct device *dev, struct i2c_of_probe_simple_ctx *ctx)
> +{
> + int ret;
> +
> + if (!ctx->supply)
> + return 0;
> +
> + dev_dbg(dev, "Enabling regulator supply \"%s\"\n", ctx->opts->supply_name);
> +
> + ret = regulator_enable(ctx->supply);
> + if (ret)
> + return ret;
> +
> + msleep(ctx->opts->post_power_on_delay_ms);
Presumably you want an "if (ctx->opts->post_power_on_delay_ms)" before
the call to msleep() since it doesn't check that for you.
> +/**
> + * i2c_of_probe_simple_enable - Enable resources for I2C OF prober simple helpers
> + * @dev: Pointer to the &struct device of the caller, only used for dev_printk() messages
> + * @data: Pointer to &struct i2c_of_probe_simple_ctx helper context.
> + *
> + * If a regulator supply was found, enable that regulator.
> + *
> + * Return: %0 on success or no-op, or a negative error number on failure.
> + */
> +int i2c_of_probe_simple_enable(struct device *dev, void *data)
> +{
> + struct i2c_of_probe_simple_ctx *ctx = data;
> + int ret;
> +
> + ret = i2c_of_probe_simple_enable_regulator(dev, ctx);
> + if (ret)
> + return ret;
> +
> + return 0;
Instead of the above, just:
return i2c_of_probe_simple_enable_regulator(dev, ctx);
I guess maybe you'd have to undo it in the next patch, but it does
make this patch stand by itself better..
Although I'd also say that if it were me I might just get rid of the
helpers and inline the stuff. The helpers don't _really_ add too much.
3 of the 4 callers are just simple wrappers of the helper and I don't
think it would be terrible to inline the last one. I guess with the
next patch when you add GPIOs it maybe makes more sense, but even then
it feels like a stretch to me. Anyway, feel free to ignore if you
want.
> +/**
> + * DOC: I2C OF component prober simple helpers
> + *
> + * Components such as trackpads are commonly connected to a devices baseboard
> + * with a 6-pin ribbon cable. That gives at most one voltage supply and one
> + * GPIO besides the I2C bus, interrupt pin, and common ground. Touchscreens,
Maybe speculate here that the GPIO is often an enable or reset line?
Otherwise you leave the reader wondering what this mysterious GPIO is
for.
