From: Tyrone Ting <kfting@xxxxxxxxxxx> Store the client address earlier since it might get called in the i2c_recover_bus logic flow at the early stage of the function npcm_i2c_master_xfer. Signed-off-by: Tyrone Ting <kfting@xxxxxxxxxxx> Reviewed-by: Tali Perry <tali.perry1@xxxxxxxxx> --- drivers/i2c/busses/i2c-npcm7xx.c | 13 ++++++++++++- 1 file changed, 12 insertions(+), 1 deletion(-) diff --git a/drivers/i2c/busses/i2c-npcm7xx.c b/drivers/i2c/busses/i2c-npcm7xx.c index 68f3d47323ab..e52e65e63600 100644 --- a/drivers/i2c/busses/i2c-npcm7xx.c +++ b/drivers/i2c/busses/i2c-npcm7xx.c @@ -2155,6 +2155,18 @@ static int npcm_i2c_master_xfer(struct i2c_adapter *adap, struct i2c_msg *msgs, } while (time_is_after_jiffies(time_left) && bus_busy); + /* + * Previously, the address was stored w/o left-shift by one bit and + * with that shift in the following call to npcm_i2c_master_start_xmit. + * + * Since there are cases that the i2c_recover_bus gets called at the + * early stage of the function npcm_i2c_master_xfer, the address is + * stored with the shift and used in the i2c_recover_bus call. + * + * The address is stored from bit 1 to bit 7 in the register for + * sending the i2c address later so it's left-shifted by 1 bit. + */ + bus->dest_addr = slave_addr << 1; if (bus_busy || bus->ber_state) { iowrite8(NPCM_I2CCST_BB, bus->reg + NPCM_I2CCST); npcm_i2c_reset(bus); @@ -2163,7 +2175,6 @@ static int npcm_i2c_master_xfer(struct i2c_adapter *adap, struct i2c_msg *msgs, } npcm_i2c_init_params(bus); - bus->dest_addr = slave_addr; bus->msgs = msgs; bus->msgs_num = num; bus->cmd_err = 0; -- 2.34.1