Re: [RFC PATCH v3 4/5] arm64: dts: mediatek: mt8173-elm-hana: Mark touchscreens and trackpads as fail

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Il 04/12/23 17:50, Doug Anderson ha scritto:
Hi,

On Sun, Dec 3, 2023 at 10:59 PM Chen-Yu Tsai <wenst@xxxxxxxxxxxx> wrote:

On Sat, Dec 2, 2023 at 8:58 AM Doug Anderson <dianders@xxxxxxxxxxxx> wrote:

Hi,

On Tue, Nov 28, 2023 at 12:45 AM Chen-Yu Tsai <wenst@xxxxxxxxxxxx> wrote:

@@ -44,6 +46,7 @@ trackpad2: trackpad@2c {
                 reg = <0x2c>;
                 hid-descr-addr = <0x0020>;
                 wakeup-source;
+               status = "fail-needs-probe";

While doing this, you could also remove the hack where the trackpad
IRQ pinctrl is listed under i2c4.

Sure. I do think we can do away with it though. According to at least one
schematic, the interrupt line has pull-ups on both sides of the voltage
shifter.

BTW, The touchscreen doesn't have pinctrl entries. This has pull-ups on
both sides of the voltage shifter as well.

I dunno if the convention is different on Mediatek boards, but at
least on boards I've been involved with in the past we've always put
pinctrl entries just to make things explicit. This meant that we
didn't rely on the firmware/bootrom/defaults to leave pulls in any
particular state. ...otherwise those external pull-ups could be
fighting with internal pull-downs, right?


MediaTek boards aren't special and there's no good reason for those to rely on
firmware/bootrom/defaults - so there is no good reason to avoid declaring any
relevant pinctrl entry.

Cheers,
Angelo





[Index of Archives]     [Linux GPIO]     [Linux SPI]     [Linux Hardward Monitoring]     [LM Sensors]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux