Re: Debugging i2c : i2cdetect cant detect a device on i2c line

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Sep 07, 2023 at 08:36:32PM +0700, Bagas Sanjaya wrote:
> [also Cc: devicetree and ARM folks]
> 
> On Thu, Sep 07, 2023 at 08:21:44AM +0530, Raul Piper wrote:
> > Hello ,
> > I am trying to detect an i2c device A on i2c1 line on  one of the Arm
> > Cortex A7 platform but not able to see any device on a given address (
> > 0x3d) .
> > 
> > Is there any parameters of i2c which i can change like rise/fall time
> > , timeout etc in a device tree or kernel source and re test it?
> > I have tried changing the i2c speed from 100KHz to 400 KHz  but no success.
> > I have even tried removing the 1.5K pull ups on the i2c lines but no result.

Honestly, from this description, I'm wondering if this posting is a joke.

I2C is entirely _reliant_ on pull-ups. It's a wire-or bus, and the
logic 1 state is created by no device pulling the signal low, thereby
allowing the pull-up resistor to pull the line to the logic 1 state.

The pull-up must be the correct strength for the devices on the bus.
If it is too strong, then a driver may not be able to pull the signal
sufficiently low for other devices to register it as a logic 0.

Conversely, the pull-up must be strong enough so that the rise-time
of the signal is sufficient to register as a logic 1.

If it's a problem with the rise time, then increasing the clock rate
will just make the situation worse.

So, if other devices work on the bus, it could be that the Vil
threshold of this device is not being achieved, whereas the other
devices are happy. Therefore, I would suggest you study the data
sheets of the device that isn't being detected.

Lastly, if the undetectable device has a reset line, it's possible
that the device isn't responding because it's being held in reset.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!



[Index of Archives]     [Linux GPIO]     [Linux SPI]     [Linux Hardward Monitoring]     [LM Sensors]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux