On 19/06/2023 17:37, Svyatoslav Ryhel wrote: > Document device tree schema which describes hot-pluggable via GPIO > i2c bus. > > Signed-off-by: Svyatoslav Ryhel <clamor95@xxxxxxxxx> 1. Don't send new version before discussion finishes. v2 after one hour is definitely not enough. Usually one day. 2. Test the patches before sending... What changed here? > --- > .../bindings/i2c/i2c-hotplug-gpio.yaml | 65 +++++++++++++++++++ > 1 file changed, 65 insertions(+) > create mode 100644 Documentation/devicetree/bindings/i2c/i2c-hotplug-gpio.yaml > > diff --git a/Documentation/devicetree/bindings/i2c/i2c-hotplug-gpio.yaml b/Documentation/devicetree/bindings/i2c/i2c-hotplug-gpio.yaml > new file mode 100644 > index 000000000000..21f2b74ca6c1 > --- /dev/null > +++ b/Documentation/devicetree/bindings/i2c/i2c-hotplug-gpio.yaml > @@ -0,0 +1,65 @@ > +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) > +%YAML 1.2 > +--- > +$id: http://devicetree.org/schemas/i2c/i2c-hotplug-gpio.yaml# > +$schema: http://devicetree.org/meta-schemas/core.yaml# > + > +title: GPIO detected hot-plugged I2C bus > + > +maintainers: > + - Michał Mirosław <mirq-linux@xxxxxxxxxxxx> > + > +description: > + Driver for hot-plugged I2C busses, where some devices on a bus "Driver" so SW? Bindings are for hardware, not for drivers. > + are hot-pluggable and their presence is indicated by GPIO line. > + > +properties: > + compatible: > + items: Drop items. > + - const: i2c-hotplug-gpio > + > + '#address-cells': > + const: 1 > + > + '#size-cells': > + const: 0 > + > + interrupts-extended: I missed last time - this is wrong. Just interrupts. > + minItems: 1 maxItems > + > + detect-gpios: > + maxItems: 1 > + > + i2c-parent: > + maxItems: 1 Discussion from v1 stands - this is a software construct, not a real device. > + > +required: > + - compatible > + - '#address-cells' > + - '#size-cells' > + - interrupts-extended > + - detect-gpios > + - i2c-parent > + > +unevaluatedProperties: false instead additionalProperties: false Anyway, don't send v3, before the discussion about the entire concept finishes. You create a software/virtual device, instead of adding these properties to bindings for a real hardware. > + > +examples: > + - | > + /* > + * Asus Transformers use I2C hotplug for attachable dock keyboard > + */ > + #include <dt-bindings/gpio/gpio.h> > + #include <dt-bindings/interrupt-controller/irq.h> > + > + i2c-dock { > + compatible = "i2c-hotplug-gpio"; > + > + #address-cells = <1>; > + #size-cells = <0>; > + > + interrupts-extended = <&gpio 164 IRQ_TYPE_EDGE_BOTH>; > + detect-gpios = <&gpio 164 GPIO_ACTIVE_LOW>; I don't think you can have both interrupt and GPIO on the same line. > + > + i2c-parent = <&gen2_i2c>; > + }; > +... Best regards, Krzysztof
