On Sat, Apr 22, 2023 at 12:56:21PM +0800, Jiawen Wu wrote:
> Add phylink support to Wangxun 10Gb Ethernet controller for the 10GBASE-R
> interface.
>
> Signed-off-by: Jiawen Wu <jiawenwu@xxxxxxxxxxxxxx>
...
> +static int txgbe_phylink_init(struct txgbe *txgbe)
> +{
> + struct phylink_config *config;
> + struct fwnode_handle *fwnode;
> + struct wx *wx = txgbe->wx;
> + phy_interface_t phy_mode;
> + struct phylink *phylink;
> +
> + config = devm_kzalloc(&wx->pdev->dev, sizeof(*config), GFP_KERNEL);
> + if (!config)
> + return -ENOMEM;
> +
> + config->dev = &wx->netdev->dev;
> + config->type = PHYLINK_NETDEV;
> + config->mac_capabilities = MAC_10000FD | MAC_1000FD | MAC_SYM_PAUSE | MAC_ASYM_PAUSE;
> + phy_mode = PHY_INTERFACE_MODE_10GBASER;
> + __set_bit(PHY_INTERFACE_MODE_10GBASER, config->supported_interfaces);
> + fwnode = software_node_fwnode(txgbe->nodes.group[SWNODE_PHYLINK]);
> + phylink = phylink_create(config, fwnode, phy_mode, &txgbe_mac_ops);
> + if (IS_ERR(phylink))
> + return PTR_ERR(phylink);
> +
> + txgbe->phylink = phylink;
> +
> + return 0;
> +}
Hi Jiawen,
txgbe_phylink_init() seems unused.
Perhaps it needs to be wired-up somewhere?
