On Tue, May 10, 2022 at 05:16:53PM +0800, Tyrone Ting wrote:
> From: Tali Perry <tali.perry1@xxxxxxxxx>
>
> NPCM can support up to 10 own slave addresses.
> In practice, only one address is actually being used.
> In order to access addresses 2 and above, need to switch
> register banks. The switch needs spinlock.
> To avoid using spinlock for this useless feature
> removed support of SA >= 2.
> Also fix returned slave event enum.
>
> Remove some comment since the bank selection is not
> required. The bank selection is not required since
> the supported slave addresses are reduced.
Fancy indentation. Please fix it in all your commit messages where it applies.
...
> + if (addr_type > I2C_SLAVE_ADDR2 && addr_type <= I2C_SLAVE_ADDR10) {
> + dev_err(bus->dev,
> + "try to enable more then 2 SA not supported\n");
Make it one line and drop {}.
> + }
...
> + if (addr_type > I2C_SLAVE_ADDR2 && addr_type <= I2C_SLAVE_ADDR10) {
> + dev_err(bus->dev,
> + "get slave: try to use more then 2 slave addresses not supported\n");
As per above be consistent with abbreviations ("SA" here, which makes line
shorter) and follow the above recommendation.
> + }
--
With Best Regards,
Andy Shevchenko
