Hello,
in the STi platform [1], the I2C and SPI controllers are handled by the
same IP, which can be configured in either one or the other mode.
This leads to warnings during the DT build and I was wondering if you could
give me some hints about how such situation should be handled since this
concern DT warnings but also bindings and YAML.
In the SoC DT (dtsi), for each IP, there are 2 entries:
One for the I2C mode (implemented by the driver i2c/busses/i2c-st.c)
i2c@9840000 {
compatible = "st,comms-ssc4-i2c";
interrupts = <GIC_SPI 112 IRQ_TYPE_LEVEL_HIGH>;
reg = <0x9840000 0x110>;
clocks = <&clk_s_c0_flexgen CLK_EXT2F_A9>;
clock-names = "ssc";
clock-frequency = <400000>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_i2c0_default>;
#address-cells = <1>;
#size-cells = <0>;
status = "disabled";
};
One for the SPI mode (implemented by the driver spi/spi-st-ssc4.c)
spi@9840000 {
compatible = "st,comms-ssc4-spi";
reg = <0x9840000 0x110>;
interrupts = <GIC_SPI 112 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clk_s_c0_flexgen CLK_EXT2F_A9>;
clock-names = "ssc";
pinctrl-0 = <&pinctrl_spi0_default>;
pinctrl-names = "default";
#address-cells = <1>;
#size-cells = <0>;
status = "disabled";
};
So basically, there are 2 nodes, one for each mode, and enabling one or the
other mode is done within the board DT.
Since the address is the same, this obviously leads to warning during the build
of the DT.
arch/arm/boot/dts/stih407-family.dtsi:363.15-376.5: Warning (unique_unit_address): /soc/i2c@9840000: duplicate unit-address (also used in node /soc/spi@9840000)
In order to fix this, I could think of only having one node (for example
I2C) in the SoC DT (dtsi) and then, within each board DT override some of the
properties (including the compatible) to make it be a SPI node when necessary.
However in such case I think this would leads to an issue regarding Yaml.
The YAML for I2C controller [2] mentions that the node name pattern should
be "^i2c(@.*)?", while in case of a SPI controller [3] it should be
"^spi(@.*|-[0-9a-f])*$".
For that reason, this way doesn't seem possible.
What would you advice to handle such case ?
Regards,
Alain
[1] arch/arm/boot/dts/stih407-family.dtsi
[2] schemas/i2c/i2c-controller.yaml
[3] Documentation/devicetree/bindings/spi/spi-controller.yaml
