On Sat, Oct 30, 2021 at 9:29 PM Hans de Goede <hdegoede@xxxxxxxxxx> wrote:
>
> So far the extcon-intel-cht-wc code has only been tested on devices with
> a Type-C connector with USB-PD, USB3 (superspeed) and DP-altmode support
> through a FUSB302 Type-C controller.
>
> Some devices with the intel-cht-wc PMIC however come with an USB-micro-B
> connector, or an USB-2 only Type-C connector without USB-PD.
>
> These device are identified by "intel,cht-wc-setup" = "bq25890,bq27520",
> since there is no Type-C controller on these devices the extcon code must
> control the Vbus 5V boost converter and the USB role switch depending on
> the detected cable-type.
...
> + if (ext->vbus_boost && ext->vbus_boost_enabled != enable) {
> + if (enable)
> + ret = regulator_enable(ext->vbus_boost);
> + else
> + ret = regulator_disable(ext->vbus_boost);
> + if (ret == 0)
> + ext->vbus_boost_enabled = enable;
> + else
> + dev_err(ext->dev, "Error updating Vbus boost regulator: %d\n", ret);
if (ret)
dev_err()
else
...
?
> + }
...
> + /*
> + * Classic micro USB-B setup, this requires controling
controlling
> + * the role-sw and vbus based on the id-pin.
> + */
--
With Best Regards,
Andy Shevchenko
