Slave i2c device on AST2500 received a lot of slave irq while it is
busy processing the response. To handle this case, adds and exports
aspeed_set_slave_busy() for controller to temporary stop slave irq
while slave is handling the response, and re-enable them again when
the response is ready.
Signed-off-by: Quan Nguyen <quan@xxxxxxxxxxxxxxxxxxxxxx>
---
v3:
+ First introduce in v3 [Quan]
drivers/i2c/busses/i2c-aspeed.c | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)
diff --git a/drivers/i2c/busses/i2c-aspeed.c b/drivers/i2c/busses/i2c-aspeed.c
index b2e9c8f0ddf7..9926d04831a2 100644
--- a/drivers/i2c/busses/i2c-aspeed.c
+++ b/drivers/i2c/busses/i2c-aspeed.c
@@ -944,6 +944,26 @@ static int aspeed_i2c_init(struct aspeed_i2c_bus *bus,
return 0;
}
+#if IS_ENABLED(CONFIG_I2C_SLAVE)
+void aspeed_set_slave_busy(struct i2c_adapter *adap, bool busy)
+{
+ struct aspeed_i2c_bus *bus = i2c_get_adapdata(adap);
+ unsigned long current_mask, flags;
+
+ spin_lock_irqsave(&bus->lock, flags);
+
+ current_mask = readl(bus->base + ASPEED_I2C_INTR_CTRL_REG);
+ if (busy)
+ current_mask &= ~(ASPEED_I2CD_INTR_RX_DONE | ASPEED_I2CD_INTR_SLAVE_MATCH);
+ else
+ current_mask |= ASPEED_I2CD_INTR_RX_DONE | ASPEED_I2CD_INTR_SLAVE_MATCH;
+ writel(current_mask, bus->base + ASPEED_I2C_INTR_CTRL_REG);
+
+ spin_unlock_irqrestore(&bus->lock, flags);
+}
+EXPORT_SYMBOL_GPL(aspeed_set_slave_busy);
+#endif
+
static int aspeed_i2c_reset(struct aspeed_i2c_bus *bus)
{
struct platform_device *pdev = to_platform_device(bus->dev);
--
2.28.0
