The ast25xx and ast26xx have, respectively, two and three configurable slave device addresses to the ast24xx's one. We only support using one at a time, but the others may come up in an indeterminate state depending on hardware/bootloader behavior, so we need to make sure we disable them so as to avoid ending up with phantom devices on the bus. Signed-off-by: Zev Weiss <zev@xxxxxxxxxxxxxxxxx> --- Changes since v1 [0]: - reduced to simplified approach suggested by Joel [0] https://lore.kernel.org/linux-arm-kernel/20200915184525.29665-1-zev@xxxxxxxxxxxxxxxxx/ drivers/i2c/busses/i2c-aspeed.c | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-) diff --git a/drivers/i2c/busses/i2c-aspeed.c b/drivers/i2c/busses/i2c-aspeed.c index 724bf30600d6..67e8b97c0c95 100644 --- a/drivers/i2c/busses/i2c-aspeed.c +++ b/drivers/i2c/busses/i2c-aspeed.c @@ -727,10 +727,14 @@ static void __aspeed_i2c_reg_slave(struct aspeed_i2c_bus *bus, u16 slave_addr) { u32 addr_reg_val, func_ctrl_reg_val; - /* Set slave addr. */ - addr_reg_val = readl(bus->base + ASPEED_I2C_DEV_ADDR_REG); - addr_reg_val &= ~ASPEED_I2CD_DEV_ADDR_MASK; - addr_reg_val |= slave_addr & ASPEED_I2CD_DEV_ADDR_MASK; + /* + * Set slave addr. Reserved bits can all safely be written with zeros + * on all of ast2[456]00, so zero everything else to ensure we only + * enable a single slave address (ast2500 has two, ast2600 has three, + * the enable bits for which are also in this register) so that we don't + * end up with additional phantom devices responding on the bus. + */ + addr_reg_val = slave_addr & ASPEED_I2CD_DEV_ADDR_MASK; writel(addr_reg_val, bus->base + ASPEED_I2C_DEV_ADDR_REG); /* Turn on slave mode. */ -- 2.31.1
