The driver's code is inconsistent in regards to the error values checking.
The correct way should be to check both positive and negative values.
This patch cleans up the error-checks in the code. Note that the
pm_runtime_get_sync() could return positive value on success, hence only
relevant parts of the code are changed by this patch.
Reviewed-by: Michał Mirosław <mirq-linux@xxxxxxxxxxxx>
Signed-off-by: Dmitry Osipenko <digetx@xxxxxxxxx>
---
drivers/i2c/busses/i2c-tegra.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c
index 44a8c7ae8509..2529d557e0b1 100644
--- a/drivers/i2c/busses/i2c-tegra.c
+++ b/drivers/i2c/busses/i2c-tegra.c
@@ -977,7 +977,7 @@ static int tegra_i2c_config_fifo_trig(struct tegra_i2c_dev *i2c_dev, size_t len)
slv_config.device_fc = true;
ret = dmaengine_slave_config(chan, &slv_config);
- if (ret < 0) {
+ if (ret) {
dev_err(i2c_dev->dev, "DMA slave config failed: %d\n",
ret);
return ret;
@@ -1219,7 +1219,7 @@ static int tegra_i2c_xfer_msg(struct tegra_i2c_dev *i2c_dev,
xfer_size,
DMA_FROM_DEVICE);
err = tegra_i2c_dma_submit(i2c_dev, xfer_size);
- if (err < 0) {
+ if (err) {
dev_err(i2c_dev->dev,
"starting RX DMA failed, err %d\n",
err);
@@ -1244,7 +1244,7 @@ static int tegra_i2c_xfer_msg(struct tegra_i2c_dev *i2c_dev,
xfer_size,
DMA_TO_DEVICE);
err = tegra_i2c_dma_submit(i2c_dev, xfer_size);
- if (err < 0) {
+ if (err) {
dev_err(i2c_dev->dev,
"starting TX DMA failed, err %d\n",
err);
--
2.27.0
