Re: [RFC PATCH v5 13/14] media: tegra-video: Add CSI MIPI pads calibration

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 7/29/20 5:52 PM, Sowjanya Komatineni wrote:

On 7/29/20 5:43 PM, Dmitry Osipenko wrote:
30.07.2020 03:27, Sowjanya Komatineni пишет:
...
Secondly, perhaps a failed calibration isn't a very critical error?
Hence just printing a warning message should be enough.
Using dev_err to report calibration failure. Are you suggesting to use
dev_warn instead of dev_err?
I meant that failing s_stream might be unnecessary.

The dev_warn should be more appropriate for a non-critical errors.

Could you please make a patch that factors all ON/OFF code paths into a
separate functions? It's a bit difficult to follow the combined code,
especially partial changes in the patches. Thanks in advance!
what do you mean by partial changes in patches?

Can you please be more clear?
Also please specify what ON/OFF code paths you are referring to when you
say to move into separate functions?
I meant to change all the code like this:

set(on) {
     if (on) {
        ...
        return;
     }

     if (!on)
       ...

     return;
}

to somewhat like this:

set(on) {
     if (on)
       ret = enable();
     else
       ret = disable();

     return ret;
}

You mean to change tegra_channel_set_stream() ?
changing tegra_channel_set_stream() to have like below will have redundant calls as most of the code b/w enable and disable is same except calling them in reverse order based on on/off and doing MIPI calibration only during ON


if (on)
    ret = enable()
else
    ret = disable()
return ret;







[Index of Archives]     [Linux GPIO]     [Linux SPI]     [Linux Hardward Monitoring]     [LM Sensors]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux