Re: [PATCH v4 3/8] dt-bindings: i2c: iproc: make 'interrupts' optional

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Feb 13, 2019 at 4:06 PM Ray Jui <ray.jui@xxxxxxxxxxxx> wrote:
>
> Hi Rob,
>
> On 2/13/2019 1:16 PM, Rob Herring wrote:
> > On Mon, Feb 04, 2019 at 03:15:49PM -0800, Ray Jui wrote:
> >> In prep for the introduction of polling mode into the driver, update the
> >> binding document to make the 'interrupts' property optional
> >>
> >> Signed-off-by: Ray Jui <ray.jui@xxxxxxxxxxxx>
> >> Signed-off-by: Rayagonda Kokatanur <rayagonda.kokatanur@xxxxxxxxxxxx>
> >> ---
> >>  .../devicetree/bindings/i2c/brcm,iproc-i2c.txt         | 10 +++++++---
> >>  1 file changed, 7 insertions(+), 3 deletions(-)
> >>
> >> diff --git a/Documentation/devicetree/bindings/i2c/brcm,iproc-i2c.txt b/Documentation/devicetree/bindings/i2c/brcm,iproc-i2c.txt
> >> index 81f982ccca31..d3a3620b1f06 100644
> >> --- a/Documentation/devicetree/bindings/i2c/brcm,iproc-i2c.txt
> >> +++ b/Documentation/devicetree/bindings/i2c/brcm,iproc-i2c.txt
> >> @@ -9,9 +9,6 @@ Required properties:
> >>      Define the base and range of the I/O address space that contain the iProc
> >>      I2C controller registers
> >>
> >> -- interrupts:
> >> -    Should contain the I2C interrupt
> >> -
> >>  - clock-frequency:
> >>      This is the I2C bus clock. Need to be either 100000 or 400000
> >>
> >> @@ -21,6 +18,13 @@ Required properties:
> >>  - #size-cells:
> >>      Always 0
> >>
> >> +Optional properties:
> >> +
> >> +- interrupts:
> >> +    Should contain the I2C interrupt. If unspecified, driver will fall back to
> >> +    polling mode
> >
> > What determines when you want to use polling mode? I'm not sure DT
> > is the best way to control this unless it's really a property of
> > the h/w. Driver behavior is really outside the scope of the DT. u-boot
> > would use polling even if an interrupt is specified, for example.
> >
> It's tied to the particular revision of the I2C controller, i.e., the
> iProc NIC i2c controller does not have interrupt line wired. In this
> case, the behavior is determined by the DT compatible string of the
> iProc I2C device. I thought that it makes sense to now move the
> 'interrupts' property to be under "Optional" than "Required" which is
> basically what this change is.

Okay, please put this detail into the commit msg.

Rob



[Index of Archives]     [Linux GPIO]     [Linux SPI]     [Linux Hardward Monitoring]     [LM Sensors]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux