You sent out the same patch series 3 times without any explanation. Very confusing. Is this the latest one that should be reviewed? Thanks, Ray On 1/8/2019 1:16 AM, Rayagonda Kokatanur wrote: > Hi, > This patchset contains support for IPROC I2C slave and NIC I2C support. > Following are the brief changes done inorder to support both IPROC I2C > slave mode and NIC I2C, > > a. Add support to allow I2C rx transfer upto 255 bytes > b. Add polling mode support to the iProc I2C driver. Polling mode is used > in certain SoCs where interrupt is not connected from the I2C block. > c. Add warpper read/write access for register to support indirect register > access. This is required in certain SoCs with this iProc I2C > block registered. > > > Ray Jui (1): > dt-bindings: i2c: iproc: make 'interrupts' optional > > Rayagonda Kokatanur (5): > i2c: iproc: add polling support > i2c: iproc: use wrapper for read/write access > dt-bindings: i2c: iproc: add "brcm,iproc-nic-i2c" compatible string > i2c: iproc: add NIC I2C support > arm64: dts: Stingray: Add NIC i2c device node > > Shreesha Rajashekar (2): > i2c: iproc: I2C read up to 255 bytes support > i2c: iproc: Add Slave mode support > > .../devicetree/bindings/i2c/brcm,iproc-i2c.txt | 14 +- > .../arm64/boot/dts/broadcom/stingray/stingray.dtsi | 18 + > drivers/i2c/busses/Kconfig | 1 + > drivers/i2c/busses/i2c-bcm-iproc.c | 767 +++++++++++++++++---- > 4 files changed, 669 insertions(+), 131 deletions(-) >
