From: Thierry Reding <treding@xxxxxxxxxx>
Some of the kerneldoc uses a strange spelling for abbreviations. Turn
them into all-uppercase and clean up some whitespace issues while at it.
Signed-off-by: Thierry Reding <treding@xxxxxxxxxx>
---
drivers/i2c/busses/i2c-tegra.c | 23 +++++++++++------------
1 file changed, 11 insertions(+), 12 deletions(-)
diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c
index 64b348a00814..c01aeb864b5b 100644
--- a/drivers/i2c/busses/i2c-tegra.c
+++ b/drivers/i2c/busses/i2c-tegra.c
@@ -145,8 +145,8 @@ enum msg_end_type {
* @has_continue_xfer_support: Continue transfer supports.
* @has_per_pkt_xfer_complete_irq: Has enable/disable capability for transfer
* complete interrupt per packet basis.
- * @has_single_clk_source: The i2c controller has single clock source. Tegra30
- * and earlier Socs has two clock sources i.e. div-clk and
+ * @has_single_clk_source: The I2C controller has single clock source. Tegra30
+ * and earlier SoCs have two clock sources i.e. div-clk and
* fast-clk.
* @has_config_load_reg: Has the config load register to load the new
* configuration.
@@ -155,7 +155,6 @@ enum msg_end_type {
* applicable if there is no fast clock source i.e. single clock
* source.
*/
-
struct tegra_i2c_hw_feature {
bool has_continue_xfer_support;
bool has_per_pkt_xfer_complete_irq;
@@ -170,22 +169,22 @@ struct tegra_i2c_hw_feature {
};
/**
- * struct tegra_i2c_dev - per device i2c context
+ * struct tegra_i2c_dev - per device I2C context
* @dev: device reference for power management
- * @hw: Tegra i2c hw feature.
- * @adapter: core i2c layer adapter information
- * @div_clk: clock reference for div clock of i2c controller.
- * @fast_clk: clock reference for fast clock of i2c controller.
+ * @hw: Tegra I2C HW feature
+ * @adapter: core I2C layer adapter information
+ * @div_clk: clock reference for div clock of I2C controller
+ * @fast_clk: clock reference for fast clock of I2C controller
* @base: ioremapped registers cookie
- * @cont_id: i2c controller id, used for for packet header
- * @irq: irq number of transfer complete interrupt
- * @is_dvc: identifies the DVC i2c controller, has a different register layout
+ * @cont_id: I2C controller ID, used for packet header
+ * @irq: IRQ number of transfer complete interrupt
+ * @is_dvc: identifies the DVC I2C controller, has a different register layout
* @msg_complete: transfer completion notifier
* @msg_err: error code for completed message
* @msg_buf: pointer to current message data
* @msg_buf_remaining: size of unsent data in the message buffer
* @msg_read: identifies read transfers
- * @bus_clk_rate: current i2c bus clock rate
+ * @bus_clk_rate: current I2C bus clock rate
*/
struct tegra_i2c_dev {
struct device *dev;
--
2.19.1
