On Fri, 2018-06-01 at 16:47 +0300, Jarkko Nikula wrote: > Trivial added debug print for dev->clk_freq doesn't necessarily tell > the > actual bus speed or mode the controller is operating. For instance it > may indicate 1 MHz Fast Mode Plus or 3.4 MHz High Speed but driver > ends up > using 400 kHz Fast Mode due missing timing parameters or missing > support > from HW. > > Add a debug print that prints the bus speed based on the validated > speed > that gets programmed into a HW. > Reviewed-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> > Signed-off-by: Jarkko Nikula <jarkko.nikula@xxxxxxxxxxxxxxx> > --- > drivers/i2c/busses/i2c-designware-master.c | 14 +++++++++++++- > 1 file changed, 13 insertions(+), 1 deletion(-) > > diff --git a/drivers/i2c/busses/i2c-designware-master.c > b/drivers/i2c/busses/i2c-designware-master.c > index e3a56c8e33c7..cd6360e51060 100644 > --- a/drivers/i2c/busses/i2c-designware-master.c > +++ b/drivers/i2c/busses/i2c-designware-master.c > @@ -48,7 +48,7 @@ static void i2c_dw_configure_fifo_master(struct > dw_i2c_dev *dev) > static void i2c_dw_set_timings_master(struct dw_i2c_dev *dev) > { > u32 ic_clk = i2c_dw_clk_rate(dev); > - const char *fp_str = ""; > + const char *mode_str, *fp_str = ""; > u32 comp_param1; > u32 sda_falling_time, scl_falling_time; > int ret; > @@ -133,6 +133,18 @@ static void i2c_dw_set_timings_master(struct > dw_i2c_dev *dev) > } > > i2c_dw_set_sda_hold(dev); > + > + switch (dev->master_cfg & DW_IC_CON_SPEED_MASK) { > + case DW_IC_CON_SPEED_STD: > + mode_str = "Standard Mode"; > + break; > + case DW_IC_CON_SPEED_HIGH: > + mode_str = "High Speed Mode"; > + break; > + default: > + mode_str = "Fast Mode"; > + } > + dev_dbg(dev->dev, "Bus speed: %s%s\n", mode_str, fp_str); > } > > /** -- Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> Intel Finland Oy