On Wed, May 23, 2018 at 06:19:45PM +0200, Wolfram Sang wrote: > On Wed, May 23, 2018 at 11:11:40AM -0500, Timur Tabi wrote: > > On Thu, May 10, 2018 at 11:13 AM, Austin Christ <austinwc@xxxxxxxxxxxxxx> wrote: > > > Add support for Fast Mode Plus (1MHz) to the I2C QUP driver and correct > > > duty cycle for Fast Mode and Fast Mode Plus. > > > > > > Add configuration in probe for Centriq devices. > > > > > > Add a command line module parameter to allow override of SCL frequency. > > > > > > [v3] > > > - correct probe patch to branch within QUPv2 segment. > > > > > > [v2] > > > - whitespace corrections > > > > > > Austin Christ (4): > > > i2c: qup: add probe path for Centriq ACPI devices > > > i2c: qup: Add support for Fast Mode Plus > > > i2c: qup: Correct duty cycle for FM and FM+ > > > i2c: qup: Add command-line parameter to override SCL frequency > > > > Wolfram, > > > > Is this patch set acceptable? We'd like to see it in 4.18, but it's > > not in your i2c/for-next branch. > > I am just waiting here for the maintainers response, too. Andy? David? Wolfram, I finally got around to looking at these. They all look good and rdy to go. Andy
