Various muxes can aggregate multiple interrupts from each i2c bus.
All of the muxes with interrupt support combine the active low irq lines
using an internal 'and' function and generate a combined active low
output. The muxes do provide the ability to read a control register to
determine which irq is active. By making the mux an irq controller isr
latenct can potentially be reduced by reading the status register and
then only calling the registered isr on that bus segment.
In addition an additional enable mask is added to work around devices
that assert irq immediately before being setup buy disabling the irq
from the mux until all devices are registered.
Phil Reid (5):
i2c: mux: pca954x: Add missing pca9542 definition to chip_desc
dt: bindings: i2c-mux-pca954x: Add documentation for interrupt
controller
i2c: mux: pca954x: Add interrupt controller support
dt: bindings: i2c-mux-pca954x: Add documentation for
i2c-mux-irq-mask-en
i2c: mux: pca954x: Add irq_mask_en to delay enabling irqs
.../devicetree/bindings/i2c/i2c-mux-pca954x.txt | 17 ++-
drivers/i2c/muxes/i2c-mux-pca954x.c | 140 ++++++++++++++++++++-
2 files changed, 155 insertions(+), 2 deletions(-)
--
1.8.3.1
--
To unsubscribe from this list: send the line "unsubscribe linux-i2c" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
