Re: [PATCH v1 1/1] add missing UARTs pins for AllWinner H3 DTS + add new I2C entries for AllWinner H3 DTS

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tuesday, April 19, 2016 at 11:11:37 AM UTC-4, Chen-Yu Tsai wrote:
> Try to wrap lines to 80 characters or less.

Ok ! I will be more careful ...

> 1 change per patch. You are making 3 changes here. a) adding shared
> pinmux settings,
> b & c) enabling uarts and i2c busses for 2 boards.
> 
> You could split them into 1 dtsi patch adding the pinmux setting, and
> then 1 for each
> board enabling the peripherals.

Fine ! I will prepare and redo a new submit with only the DTSI for now.

> Perhaps they were enabled before the policy was enacted, or it just
> slipped through. I
> contributed to a few. But for many boards we might not have schematics
> or the actual
> device to check.

Understood ! But sometimes things are so generic, like having uart0 and not having uart1 make it looks a bit strange. Some other times having some i2c2 because of PMIC while not having i2c0 and i2c1 is also strange.

> How would you determine what the most common usage is for "development boards"?
> If the vendor explicitly designed the pins to be used one way, and even printed
> the description on the board, then you may have a valid argument. But even then,
> with the C.H.I.P., they are going with DT overlays.
> 
> It shouldn't be hard for an end user to modify the DT. And with I2C devices, it
> is almost a requirement.

Ok ! I will look if it is easier to do the rest with overlays.

[Index of Archives]     [Linux GPIO]     [Linux SPI]     [Linux Hardward Monitoring]     [LM Sensors]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux