On Tue, Jul 21, 2015 at 06:11:05PM +0530, Vaibhav Hiremath wrote: > With addition of PXA910 family of devices, the TWSI module supports > new feature which allows us to adjust SCLK. i2c-pxa driver takes input > configuration in nsec and converts it to respective bit-fields, > > - i2c-sclk-low-time-ns : SCLK low time (tlow) > This property is used along with mode selection. > - i2c-sclk-high-time-ns : SCLK high time (thigh) > - i2c-start-hold-time-ns : Used in case of high speed mode for start bit > hold/setup wait counter. > - i2c-stop-hold-time-ns : Used in case of high speed mode for stop bit > hold/setup wait counter. > - i2c-sda-hold-time-ns : Used to calculate hold/setup wait counter for > standard and fast mode. Again, these should have a mrvl prefix..very specific to this PXA controller. -Matt > Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath@xxxxxxxxxx> > --- > Documentation/devicetree/bindings/i2c/i2c-pxa.txt | 13 +++++++++++++ > 1 file changed, 13 insertions(+) > > diff --git a/Documentation/devicetree/bindings/i2c/i2c-pxa.txt b/Documentation/devicetree/bindings/i2c/i2c-pxa.txt > index 9657db5..bb4df60 100644 > --- a/Documentation/devicetree/bindings/i2c/i2c-pxa.txt > +++ b/Documentation/devicetree/bindings/i2c/i2c-pxa.txt > @@ -23,12 +23,25 @@ Optional properties : > - i2c-disable-after-xfer : If set, driver will disable I2C module > after msg xfer and enable it again before xfer. > > + (Applicable to PXA910 family): > + > + - i2c-sclk-low-time-ns : SCLK low time (tlow), for standard/fast/high > + speed mode. > + This property is used along with mode selection. Driver uses this property > + to set low/high time for standard and fast speed mode, as HW counter > + bit-field is same for both. > + - i2c-sclk-high-time-ns : SCLK high time (thigh), Used in case of high speed > + mode only. > + > Examples: > twsi1: i2c@d4011000 { > compatible = "mrvl,mmp-twsi"; > reg = <0xd4011000 0x1000>; > interrupts = <7>; > mrvl,i2c-fast-mode; > + > + i2c-sclk-low-time-ns = <988>; > + i2c-sclk-high-time-ns = <988>; > }; > > twsi2: i2c@d4025000 { > -- > 1.9.1 > > > _______________________________________________ > linux-arm-kernel mailing list > linux-arm-kernel@xxxxxxxxxxxxxxxxxxx > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel -- To unsubscribe from this list: send the line "unsubscribe linux-i2c" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html