Hello, I have been dealing with a PCA9665 controller for i2c. During interactions with some hardware, it is common for the bus to get into a unusable state (in this case, SCL is pulled low by a slave). But, even after disconnecting all the slaves, I am not able to get the bus working again. Reading the algo code, I see there are reset features for both chips supported by the driver, so I wonder if there is some way or tool to trigger this reset on request (that is, after I have disconnected all the slaves). -- Nuno Silva (aka njsg) Radiotieteen ja -tekniikan laitos Aalto-yliopiston sähkötekniikan korkeakoulu -- To unsubscribe from this list: send the line "unsubscribe linux-i2c" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
