On Thu, Jul 21, 2011 at 12:23 PM, Shubhrajyoti D <shubhrajyoti@xxxxxx> wrote:
> The reset in the driver at init is not needed
> anymore as the hwmod framework takes care of
> reseting it.
>
> Signed-off-by: Shubhrajyoti D <shubhrajyoti@xxxxxx>
> ---
> drivers/i2c/busses/i2c-omap.c | 57 +++++++++++------------------------------
> 1 files changed, 15 insertions(+), 42 deletions(-)
>
> diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c
> index 8f87a37..d6ea7de 100644
> --- a/drivers/i2c/busses/i2c-omap.c
> +++ b/drivers/i2c/busses/i2c-omap.c
> @@ -155,9 +155,6 @@ enum {
> #define OMAP_I2C_SYSTEST_SDA_O (1 << 0) /* SDA line drive out */
> #endif
>
> -/* OCP_SYSSTATUS bit definitions */
> -#define SYSS_RESETDONE_MASK (1 << 0)
> -
> /* OCP_SYSCONFIG bit definitions */
> #define SYSC_CLOCKACTIVITY_MASK (0x3 << 8)
> #define SYSC_SIDLEMODE_MASK (0x3 << 3)
> @@ -182,6 +179,8 @@ struct omap_i2c_dev {
> u32 latency; /* maximum mpu wkup latency */
> void (*set_mpu_wkup_lat)(struct device *dev,
> long latency);
> + int (*device_reset)(struct device *dev);
> +
> u32 speed; /* Speed of bus in Khz */
> u16 cmd_err;
> u8 *buf;
> @@ -332,7 +331,6 @@ static int omap_i2c_init(struct omap_i2c_dev *dev)
> u16 psc = 0, scll = 0, sclh = 0, buf = 0;
> u16 fsscll = 0, fssclh = 0, hsscll = 0, hssclh = 0;
> unsigned long fclk_rate = 12000000;
> - unsigned long timeout;
> unsigned long internal_clk = 0;
> struct clk *fclk;
> struct platform_device *pdev;
> @@ -341,43 +339,7 @@ static int omap_i2c_init(struct omap_i2c_dev *dev)
> pdev = to_platform_device(dev->dev);
> pdata = pdev->dev.platform_data;
>
> - if (dev->rev >= OMAP_I2C_OMAP1_REV_2) {
> - /* Disable I2C controller before soft reset */
> - omap_i2c_write_reg(dev, OMAP_I2C_CON_REG,
> - omap_i2c_read_reg(dev, OMAP_I2C_CON_REG) &
> - ~(OMAP_I2C_CON_EN));
> -
> - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, SYSC_SOFTRESET_MASK);
> - /* For some reason we need to set the EN bit before the
> - * reset done bit gets set. */
> - timeout = jiffies + OMAP_I2C_TIMEOUT;
> - omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, OMAP_I2C_CON_EN);
> - while (!(omap_i2c_read_reg(dev, OMAP_I2C_SYSS_REG) &
> - SYSS_RESETDONE_MASK)) {
> - if (time_after(jiffies, timeout)) {
> - dev_warn(dev->dev, "timeout waiting "
> - "for controller reset\n");
> - return -ETIMEDOUT;
> - }
> - msleep(1);
> - }
> -
> - /* SYSC register is cleared by the reset; rewrite it */
> - if (dev->rev == OMAP_I2C_REV_ON_2430) {
> -
> - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG,
> - SYSC_AUTOIDLE_MASK);
> -
> - } else if (dev->rev >= OMAP_I2C_REV_ON_3430) {
> - dev->syscstate = SYSC_AUTOIDLE_MASK;
> - dev->syscstate |= SYSC_ENAWAKEUP_MASK;
> - dev->syscstate |= (SYSC_IDLEMODE_SMART <<
> - __ffs(SYSC_SIDLEMODE_MASK));
> - dev->syscstate |= (SYSC_CLOCKACTIVITY_FCLK <<
> - __ffs(SYSC_CLOCKACTIVITY_MASK));
> -
> - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG,
> - dev->syscstate);
> + if (dev->rev >= OMAP_I2C_REV_ON_3430) {
> /*
> * Enabling all wakup sources to stop I2C freezing on
> * WFI instruction.
one extra level of indentation
> @@ -388,7 +350,7 @@ static int omap_i2c_init(struct omap_i2c_dev *dev)
> omap_i2c_write_reg(dev, OMAP_I2C_WE_REG,
> dev->westate);
> }
same
> - }
> +
spurious change, This comment applies to other patches in the series.
> omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, 0);
>
> if (pdata->flags & OMAP_I2C_FLAG_ALWAYS_ARMXOR_CLK) {
--
To unsubscribe from this list: send the line "unsubscribe linux-i2c" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
