[PATCH RESEND v9 33/36] KVM: VMX: Add VMX_DO_FRED_EVENT_IRQOFF for IRQ/NMI handling

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Compared to an IDT stack frame, a FRED stack frame has extra 16 bytes of
information pushed at the regular stack top and 8 bytes of error code _always_
pushed at the regular stack bottom, add VMX_DO_FRED_EVENT_IRQOFF to generate
FRED stack frames with event type and vector properly set. Thus, IRQ/NMI can
be handled with the existing approach when FRED is enabled.

For IRQ handling, general purpose registers are pushed to the stack to form
a pt_regs structure, which is then used to call external_interrupt(). As a
result, IRQ handling no longer re-enters the noinstr code.

Tested-by: Shan Kang <shan.kang@xxxxxxxxx>
Signed-off-by: Xin Li <xin3.li@xxxxxxxxx>
---

Changes since v8:
* Add a new macro VMX_DO_FRED_EVENT_IRQOFF for FRED instead of refactoring
  VMX_DO_EVENT_IRQOFF (Sean Christopherson).
* Do NOT use a trampoline, just LEA+PUSH the return RIP, PUSH the error code,
  and jump to the FRED kernel entry point for NMI or call external_interrupt()
  for IRQs (Sean Christopherson).
* Call external_interrupt() only when FRED is enabled, and convert the non-FRED
  handling to external_interrupt() after FRED lands (Sean Christopherson).
---
 arch/x86/kvm/vmx/vmenter.S | 88 ++++++++++++++++++++++++++++++++++++++
 arch/x86/kvm/vmx/vmx.c     | 19 ++++++--
 2 files changed, 104 insertions(+), 3 deletions(-)

diff --git a/arch/x86/kvm/vmx/vmenter.S b/arch/x86/kvm/vmx/vmenter.S
index 07e927d4d099..5ee6a57b59a5 100644
--- a/arch/x86/kvm/vmx/vmenter.S
+++ b/arch/x86/kvm/vmx/vmenter.S
@@ -2,12 +2,14 @@
 #include <linux/linkage.h>
 #include <asm/asm.h>
 #include <asm/bitsperlong.h>
+#include <asm/fred.h>
 #include <asm/kvm_vcpu_regs.h>
 #include <asm/nospec-branch.h>
 #include <asm/percpu.h>
 #include <asm/segment.h>
 #include "kvm-asm-offsets.h"
 #include "run_flags.h"
+#include "../../entry/calling.h"
 
 #define WORD_SIZE (BITS_PER_LONG / 8)
 
@@ -31,6 +33,80 @@
 #define VCPU_R15	__VCPU_REGS_R15 * WORD_SIZE
 #endif
 
+#ifdef CONFIG_X86_FRED
+.macro VMX_DO_FRED_EVENT_IRQOFF branch_insn branch_target nmi=0
+	/*
+	 * Unconditionally create a stack frame, getting the correct RSP on the
+	 * stack (for x86-64) would take two instructions anyways, and RBP can
+	 * be used to restore RSP to make objtool happy (see below).
+	 */
+	push %_ASM_BP
+	mov %_ASM_SP, %_ASM_BP
+
+	/*
+	 * Don't check the FRED stack level, the call stack leading to this
+	 * helper is effectively constant and shallow (relatively speaking).
+	 *
+	 * Emulate the FRED-defined redzone and stack alignment.
+	 */
+	sub $(FRED_CONFIG_REDZONE_AMOUNT << 6), %rsp
+	and $FRED_STACK_FRAME_RSP_MASK, %rsp
+
+	/*
+	 * A FRED stack frame has extra 16 bytes of information pushed at the
+	 * regular stack top compared to an IDT stack frame.
+	 */
+	push $0		/* Reserved by FRED, must be 0 */
+	push $0		/* FRED event data, 0 for NMI and external interrupts */
+
+	shl $32, %rdi				/* FRED event type and vector */
+	.if \nmi
+	bts $FRED_SSX_NMI_BIT, %rdi		/* Set the NMI bit */
+	.endif
+	bts $FRED_SSX_64_BIT_MODE_BIT, %rdi	/* Set the 64-bit mode */
+	or $__KERNEL_DS, %rdi
+	push %rdi
+	push %rbp
+	pushf
+	mov $__KERNEL_CS, %rax
+	push %rax
+
+	/*
+	 * Unlike the IDT event delivery, FRED _always_ pushes an error code
+	 * after pushing the return RIP, thus the CALL instruction CANNOT be
+	 * used here to push the return RIP, otherwise there is no chance to
+	 * push an error code before invoking the IRQ/NMI handler.
+	 *
+	 * Use LEA to get the return RIP and push it, then push an error code.
+	 */
+	lea 1f(%rip), %rax
+	push %rax
+	push $0		/* FRED error code, 0 for NMI and external interrupts */
+
+	.if \nmi == 0
+	PUSH_REGS
+	mov %rsp, %rdi
+	.endif
+
+	\branch_insn \branch_target
+
+	.if \nmi == 0
+	POP_REGS
+	.endif
+
+1:
+	/*
+	 * "Restore" RSP from RBP, even though IRET has already unwound RSP to
+	 * the correct value.  objtool doesn't know the callee will IRET and,
+	 * without the explicit restore, thinks the stack is getting walloped.
+	 * Using an unwind hint is problematic due to x86-64's dynamic alignment.
+	 */
+	mov %_ASM_BP, %_ASM_SP
+	pop %_ASM_BP
+	RET
+.endm
+#endif
+
 .macro VMX_DO_EVENT_IRQOFF call_insn call_target
 	/*
 	 * Unconditionally create a stack frame, getting the correct RSP on the
@@ -299,6 +375,12 @@ SYM_INNER_LABEL_ALIGN(vmx_vmexit, SYM_L_GLOBAL)
 
 SYM_FUNC_END(__vmx_vcpu_run)
 
+#ifdef CONFIG_X86_FRED
+SYM_FUNC_START(vmx_do_fred_nmi_irqoff)
+	VMX_DO_FRED_EVENT_IRQOFF jmp fred_entrypoint_kernel nmi=1
+SYM_FUNC_END(vmx_do_fred_nmi_irqoff)
+#endif
+
 SYM_FUNC_START(vmx_do_nmi_irqoff)
 	VMX_DO_EVENT_IRQOFF call asm_exc_nmi_kvm_vmx
 SYM_FUNC_END(vmx_do_nmi_irqoff)
@@ -357,6 +439,12 @@ SYM_FUNC_START(vmread_error_trampoline)
 SYM_FUNC_END(vmread_error_trampoline)
 #endif
 
+#ifdef CONFIG_X86_FRED
+SYM_FUNC_START(vmx_do_fred_interrupt_irqoff)
+	VMX_DO_FRED_EVENT_IRQOFF call external_interrupt
+SYM_FUNC_END(vmx_do_fred_interrupt_irqoff)
+#endif
+
 SYM_FUNC_START(vmx_do_interrupt_irqoff)
 	VMX_DO_EVENT_IRQOFF CALL_NOSPEC _ASM_ARG1
 SYM_FUNC_END(vmx_do_interrupt_irqoff)
diff --git a/arch/x86/kvm/vmx/vmx.c b/arch/x86/kvm/vmx/vmx.c
index 0ecf4be2c6af..4e90c69a92bf 100644
--- a/arch/x86/kvm/vmx/vmx.c
+++ b/arch/x86/kvm/vmx/vmx.c
@@ -6890,6 +6890,14 @@ static void vmx_apicv_post_state_restore(struct kvm_vcpu *vcpu)
 	memset(vmx->pi_desc.pir, 0, sizeof(vmx->pi_desc.pir));
 }
 
+#ifdef CONFIG_X86_FRED
+void vmx_do_fred_interrupt_irqoff(unsigned int vector);
+void vmx_do_fred_nmi_irqoff(unsigned int vector);
+#else
+#define vmx_do_fred_interrupt_irqoff(x) BUG()
+#define vmx_do_fred_nmi_irqoff(x) BUG()
+#endif
+
 void vmx_do_interrupt_irqoff(unsigned long entry);
 void vmx_do_nmi_irqoff(void);
 
@@ -6932,14 +6940,16 @@ static void handle_external_interrupt_irqoff(struct kvm_vcpu *vcpu)
 {
 	u32 intr_info = vmx_get_intr_info(vcpu);
 	unsigned int vector = intr_info & INTR_INFO_VECTOR_MASK;
-	gate_desc *desc = (gate_desc *)host_idt_base + vector;
 
 	if (KVM_BUG(!is_external_intr(intr_info), vcpu->kvm,
 	    "unexpected VM-Exit interrupt info: 0x%x", intr_info))
 		return;
 
 	kvm_before_interrupt(vcpu, KVM_HANDLING_IRQ);
-	vmx_do_interrupt_irqoff(gate_offset(desc));
+	if (cpu_feature_enabled(X86_FEATURE_FRED))
+		vmx_do_fred_interrupt_irqoff(vector);	/* Event type is 0 */
+	else
+		vmx_do_interrupt_irqoff(gate_offset((gate_desc *)host_idt_base + vector));
 	kvm_after_interrupt(vcpu);
 
 	vcpu->arch.at_instruction_boundary = true;
@@ -7225,7 +7235,10 @@ static noinstr void vmx_vcpu_enter_exit(struct kvm_vcpu *vcpu,
 	if ((u16)vmx->exit_reason.basic == EXIT_REASON_EXCEPTION_NMI &&
 	    is_nmi(vmx_get_intr_info(vcpu))) {
 		kvm_before_interrupt(vcpu, KVM_HANDLING_NMI);
-		vmx_do_nmi_irqoff();
+		if (cpu_feature_enabled(X86_FEATURE_FRED))
+			vmx_do_fred_nmi_irqoff((EVENT_TYPE_NMI << 16) | NMI_VECTOR);
+		else
+			vmx_do_nmi_irqoff();
 		kvm_after_interrupt(vcpu);
 	}
 
-- 
2.34.1




[Index of Archives]     [Linux Samsung SoC]     [Linux Rockchip SoC]     [Linux Actions SoC]     [Linux for Synopsys ARC Processors]     [Linux NFS]     [Linux NILFS]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]


  Powered by Linux