Make PCI_OP_READ and PCI_USER_READ_CONFIG set the data value with error response (~0), when the PCI device read by a host controller fails. This ensures that the controller drivers no longer need to fabricate (~0) value when they detect error. It also gurantees that the error response (~0) is always set when the controller drivers fails to read a config register from a device. This makes error response fabrication consistent and helps in removal of a lot of repeated code. Suggested-by: Rob Herring <robh@xxxxxxxxxx> Reviewed-by: Rob Herring <robh@xxxxxxxxxx> Signed-off-by: Naveen Naidu <naveennaidu479@xxxxxxxxx> --- drivers/pci/access.c | 10 ++++++++-- 1 file changed, 8 insertions(+), 2 deletions(-) diff --git a/drivers/pci/access.c b/drivers/pci/access.c index 46935695cfb9..0f732ba2f71a 100644 --- a/drivers/pci/access.c +++ b/drivers/pci/access.c @@ -42,7 +42,10 @@ int noinline pci_bus_read_config_##size \ if (PCI_##size##_BAD) return PCIBIOS_BAD_REGISTER_NUMBER; \ pci_lock_config(flags); \ res = bus->ops->read(bus, devfn, pos, len, &data); \ - *value = (type)data; \ + if (res) \ + SET_PCI_ERROR_RESPONSE(value); \ + else \ + *value = (type)data; \ pci_unlock_config(flags); \ return res; \ } @@ -228,7 +231,10 @@ int pci_user_read_config_##size \ ret = dev->bus->ops->read(dev->bus, dev->devfn, \ pos, sizeof(type), &data); \ raw_spin_unlock_irq(&pci_lock); \ - *val = (type)data; \ + if (ret) \ + SET_PCI_ERROR_RESPONSE(val); \ + else \ + *val = (type)data; \ return pcibios_err_to_errno(ret); \ } \ EXPORT_SYMBOL_GPL(pci_user_read_config_##size); -- 2.25.1
