On Wed, Oct 30, 2024 at 05:40:58PM -0500, Grant Peltier wrote: > Some applications require Vout to be higher than the detectable voltage > range of the Vsense pin for a given rail. In such applications, a voltage > divider may be placed between Vout and the Vsense pin, but this results > in erroneous telemetry being read back from the part. This change adds > support for a voltage divider to be defined in the devicetree for a (or > multiple) specific rail(s) for a supported digital multiphase device and > for the applicable Vout telemetry to be scaled based on the voltage > divider configuration. > > This change copies the implementation of the vout-voltage-divider > devicetree property defined in the maxim,max20730 bindings schema since > it is the best fit for the use case of scaling hwmon PMBus telemetry. The > generic voltage-divider property used by many iio drivers was determined > to be a poor fit because that schema is tied directly to iio and the > isl68137 driver is not an iio driver. > > Signed-off-by: Grant Peltier <grantpeltier93@xxxxxxxxx> Applied, after fixing several alignment problems reported by checkpatch --strict. Guenter
