On 23/10/2024 16:42, Guenter Roeck wrote:
On 10/23/24 05:41, Ahmad Khalifa wrote:
On 22/10/2024 14:40, Guenter Roeck wrote:
On 10/22/24 03:13, Frank Crawford wrote:
On Tue, 2024-10-22 at 17:13 +0800, Ai Chao wrote:
Add support for IT8625E on Centerm P410.
...
Can I just add that it isn't a good idea to use the same type for
different chips. There are some specific differences between the
chips, which mean that it should have its own entry in
static const struct it87_devices it87_devices[]
even if currently they are very similar.
According to the information I have, the ADC voltage is different,
and 8628 supports PECI but 8625 doesn't. Most importantly, 8625
has multiple register banks. There are also some differences in
fan control; 8628 can explicitly turn fans off using register bits.
Just mapping the chip to it8628 may be convenient, but it is not
acceptable.
Side question here. The standard for an acceptable chip driver is pretty
high (and rightfully so). But a common use case centres around readonly
display of information: temp/fan/in readings. Even just 2-3 readings are
better than nothing.
Example, I still have to use Frank's out of tree it87 for my IT8688.
It works perfectly fine for me, but still not possible to merge that
device into hwmon's it87.
This IT8625 is another example. The NCT6701D-R will be one more shortly.
For the most part you can use the kernel driver with force_id parameter.
That is no different than your suggested patch.
Nuvoton is usually very supportive, so I don't see a problem adding
support for NCT6701D-R if someone is willing to spend the time to write
a driver (or adding support to an existing driver if the chip is similar).
It's on my radar when they release the mini-ITX X870 board over here.
Will need to find the datasheet then.
A readonly driver that is configurable from userspace would help in that
use case. It can be configured for known devices without datasheets or
for testing new devices. Wouldn't even need to access superio config
space.
Filesystem has fuse, i2c has i2c-dev, input has evdev, ...
Would something similar be acceptable for hwmon?
I would have to details of a proposal, but It seems unlikely.
After all, chip details have to be sufficiently known to provide
any driver, even a userspace one. Also, the hwmon ABI (i.s., its set
of sysfs entries) isn't that special that it would warrant such a
kernel infrastructure. If at all, it might make more sense to add
support for this, for example, to libsensors.
Why not libsensors?
Access to ACPI and IO ports (without special file capabilities).
Access to the hwmon sysfs ABI in place of libsensors (as libsensors has
no movement at all - not the best reason, I know)
Maybe access to WMI too, but didn't need it in my tests with gigabyte
WMI, as through ACPI you get fan access in addition to temp
I'll clean up something I used in the past and send an RFC for it.
--
Regards,
Ahmad
