On 7/24/24 17:54, Tzung-Bi Shih wrote:
On Wed, Jul 24, 2024 at 10:40:20AM -0700, Guenter Roeck wrote:
On 7/24/24 08:41, Tzung-Bi Shih wrote:
On Wed, Jul 24, 2024 at 07:25:31AM -0700, Guenter Roeck wrote:
On 7/24/24 06:03, Tzung-Bi Shih wrote:
On Tue, Jul 23, 2024 at 08:44:43AM -0700, Guenter Roeck wrote:
+ if (data->type != max6581) {
+ if (of_property_read_bool(node, "resistance-cancellation") &&
+ chip->valid_conf & MAX6697_CONF_RESISTANCE) {
+ confreg |= MAX6697_CONF_RESISTANCE;
+ factor = 1;
+ }
+ } else {
+ if (of_property_read_u32(node, "resistance-cancellation", &vals[0])) {
+ if (of_property_read_bool(node, "resistance-cancellation"))
+ vals[0] = 0xfe;
+ else
+ vals[0] = 0;
+ }
+
+ factor = hweight8(vals[0] & 0xfe);
It doesn't AND with 0xfe originally.
Yes, but the original code uses the value in
factor += hweight8(pdata->resistance_cancellation >> 1);
ret = i2c_smbus_write_byte_data(client, MAX6581_REG_RESISTANCE,
pdata->resistance_cancellation >> 1);
which is effectively the same. I can't just use
factor = hweight8(vals[0] >> 1);
because, unlike resistance_cancellation, val[] is an u32 array which would
not auto-mask the upper bits.
If you are worrying about:
* MSB, it should be fine as it should only prepend 0s for right shift on
unsigned.
* BIT(8), other `val[0] >> 1` should also share the same concern.
BIT(8) is the concern. Yes, you are correct, I'll change the code to
val[0] &= 0xfe;
factor = hweight8(vals[0]);
...
With that,
Reviewed-by: Tzung-Bi Shih <tzungbi@xxxxxxxxxx>
Note: there is another `vals[0] >> 1` for MAX6581_REG_IDEALITY_SELECT.
Good point. I masked that as well.
Thanks a lot for the reviews,
Guenter
