Hi Guenter,
On 7/1/24 11:23 PM, Guenter Roeck wrote:
The default value of the maximum fan speed limit register is 0,
essentially translating to an unlimited fan speed. When reading
the limit, a value of 0 is reported in this case. However, writing
a value of 0 results in writing a value of 0xffff into the register,
which is inconsistent.
To solve the problem, permit writing a limit of 0 for the maximim fan
speed, effectively translating to "no limit". Write 0 into the register
if a limit value of 0 is written. Otherwise limit the range to
<1..6000000> and write 1..0xffff into the register. This ensures that
reading and writing from and to a limit register return the same value
while at the same time not changing reported values when reading the
speed or limits.
While at it, restrict fan limit writes to non-negative numbers; writing
a negative limit does not make sense and should be reported instead of
being corrected.
Signed-off-by: Guenter Roeck <linux@xxxxxxxxxxxx>
---
v2: Do not accept negative fan speed values
Display fan speed and speed limit as 0 if register value is 0
(instead of 6000000), as in original code.
Only permit writing 0 (unlimited) for the maximum fan speed.
drivers/hwmon/amc6821.c | 13 +++++++++----
1 file changed, 9 insertions(+), 4 deletions(-)
diff --git a/drivers/hwmon/amc6821.c b/drivers/hwmon/amc6821.c
index eb2d5592a41a..9c19d4d278ec 100644
--- a/drivers/hwmon/amc6821.c
+++ b/drivers/hwmon/amc6821.c
@@ -617,15 +617,20 @@ static ssize_t fan_store(struct device *dev, struct device_attribute *attr,
{
struct amc6821_data *data = dev_get_drvdata(dev);
struct i2c_client *client = data->client;
- long val;
+ unsigned long val;
int ix = to_sensor_dev_attr(attr)->index;
- int ret = kstrtol(buf, 10, &val);
+ int ret = kstrtoul(buf, 10, &val);
if (ret)
return ret;
- val = 1 > val ? 0xFFFF : 6000000/val;
+
+ /* The minimum fan speed must not be unlimited (0) */
+ if (ix == IDX_FAN1_MIN && !val)
+ return -EINVAL;
+
+ val = val > 0 ? 6000000 / clamp_val(val, 1, 6000000) : 0;
I'm wondering if we shouldn't check !val for min after this line
instead? Otherwise we allow 6000001+RPM speeds... which is technically
unlimited.
Nitpicking though, therefore:
Reviewed-by: Quentin Schulz <quentin.schulz@xxxxxxxxx>
Thanks!
Quentin
