On 6/3/24 05:31, Stephen Horvath wrote:
Hi,
On 1/6/24 09:05, Guenter Roeck wrote:
Add suspend/resume support to ensure that limit and configuration
registers are updated and synchronized after a suspend/resume cycle.
Cc: Armin Wolf <W_Armin@xxxxxx>
Signed-off-by: Guenter Roeck <linux@xxxxxxxxxxxx>
---
v3: No change
v2: New patch
RFT: I tested the patch through a suspend/resume cycle, and it seems
to work, but I am not sure if that had any effect because,
after all, the memory is still active during suspend/resume.
I was unable to test a hibernation cycle with my system.
For me, the driver just reports 0°C after suspend/resume, but works fine beforehand, tested on both my desktop and laptop, with kernel 6.9.3 and 6.10.0-rc2 (on the laptop only).
Hibernation does seem to work fine though (at least on 6.9.3).
Thanks a lot for the report. I can confirm that this happens if the enable
attribute was not touched before the suspend/resume cycle. I'll send another
version with the fix.
Guenter
