On Fri, Nov 03, 2023 at 07:09:27AM -0700, Guenter Roeck wrote:
> On 11/3/23 05:51, Carlos Menin wrote:
> > Add support for NXP's PCF85053A RTC chip.
> >
> > Signed-off-by: Carlos Menin <menin@xxxxxxxxxxxxxxxxx>
> > Reviewed-by: Sergio Prado <sergio.prado@xxxxxxxxxxxxxx>
> > ---
>
> [ ... ]
>
> > +static int pcf85053a_bvl_to_mv(unsigned int bvl)
> > +{
> > + long mv_table[] = {
> > + 1700,
> > + 1900,
> > + 2100,
> > + 2300,
> > + 2500,
> > + 2700,
> > + 2900,
> > + 3100,
>
> How are those numbers determined ? The datasheet gives voltage ranges.
> I'd have assumed that the center of those ranges is chosen, but for the
> most part it is the maximum, except for 2900 which is a bit above center
> and 3100 for "> 3.0V". Not that I care too much, but it seems to me that
> using the center voltage for each range would be more consistent.
>
I just used numbers that would result in the same step between levels
(200 mV) at the same time they would fit in the ranges, but I agree
that using the center of the ranges makes sense. In this case which
values would you suggest for <= 1.7 and > 3.0 ?
> > +static int pcf85053a_hwmon_register(struct device *dev, const char *name)
> > +{
> > + struct pcf85053a *pcf85053a = dev_get_drvdata(dev);
> > + struct device *hwmon_dev;
> > +
> > + hwmon_dev = devm_hwmon_device_register_with_info(dev, name, pcf85053a,
> > + &pcf85053a_hwmon_chip_info,
> > + 0);
>
> This won't compile if CONFIG_HWMON=n or if CONFIG_RTC_DRV_PCF85053A=y and
> CONFIG_HWMON=m.
>
> Guenter
>
I will add dependencies in the Kconfig file.
Thanks for reviewing,
Carlos
