On Tue, 25 Jul 2023 13:40:26 +0200, Naresh Solanki wrote: > From: Patrick Rudolph <patrick.rudolph@xxxxxxxxxxxxx> > > The TDA38640 has a bug in SVID mode and to enable a workaround > remove the TDA38640 from trivial-devices and add a complete schema. > > The schema adds the custom property 'infineon,en-pin-fixed-level' to > signal a fixed level on the ENABLE pin and to enable the workaround. > When the ENABLE pin is left floating it's internally pulled low. > > If not specified the driver will continue to use the PMBUS_OPERATION > register to enable the regulator. When specified the driver will use > the PMBUS_ON_OFF_CONFIG register to enable the regulator. > > Signed-off-by: Patrick Rudolph <patrick.rudolph@xxxxxxxxxxxxx> > Signed-off-by: Naresh Solanki <Naresh.Solanki@xxxxxxxxxxxxx> > --- > .../hwmon/pmbus/infineon,tda38640.yaml | 50 +++++++++++++++++++ > .../devicetree/bindings/trivial-devices.yaml | 2 - > 2 files changed, 50 insertions(+), 2 deletions(-) > create mode 100644 Documentation/devicetree/bindings/hwmon/pmbus/infineon,tda38640.yaml > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: dtschema/dtc warnings/errors: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/hwmon/pmbus/infineon,tda38640.yaml: 'maintainers' is a required property hint: Metaschema for devicetree binding documentation from schema $id: http://devicetree.org/meta-schemas/core.yaml# doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230725114030.1860571-1-Naresh.Solanki@xxxxxxxxxxxxx The base for the series is generally the latest rc1. A different dependency should be noted in *this* patch. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit after running the above command yourself. Note that DT_SCHEMA_FILES can be set to your schema file to speed up checking your schema. However, it must be unset to test all examples with your schema.
