Hi,
make oldconfig asks me here on a x86 machine about this below and it
looks like this should depend on some P8 config item so that it doesn't
show on other architectures.
Right?
Thx.
CONFIG_SENSORS_OCC_P8_I2C:
This option enables support for monitoring sensors provided by the
On-Chip Controller (OCC) on a POWER8 processor. However, this driver
can only run on a baseboard management controller (BMC) connected to
the P8, not the POWER processor itself. Communications with the OCC are
established through I2C bus.
This driver can also be built as a module. If so, the module will be
called occ-p8-hwmon.
Symbol: SENSORS_OCC_P8_I2C [=n]
Type : tristate
Defined at drivers/hwmon/occ/Kconfig:6
Prompt: POWER8 OCC through I2C
Depends on: HWMON [=y] && I2C [=y]
Location:
-> Device Drivers
-> Hardware Monitoring support (HWMON [=y])
-> POWER8 OCC through I2C (SENSORS_OCC_P8_I2C [=n])
Selects: SENSORS_OCC [=n]
--
Regards/Gruss,
Boris.
https://people.kernel.org/tglx/notes-about-netiquette
