The first 'for' loop of asus_wmi_configure_sensor_setup() only computes
the number and type of sensors that exist in the system.
Here, the 'temp_sensor' structure is only used to store the data collected
by asus_wmi_sensor_info(). There is no point in using a devm_ variant for
this first allocation and it can be freed just after this initial loop.
So use kzalloc()/kfree() to save a few bytes of memory that would be kept
allocated for no good reason otherwise.
Signed-off-by: Christophe JAILLET <christophe.jaillet@xxxxxxxxxx>
---
drivers/hwmon/asus_wmi_sensors.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/hwmon/asus_wmi_sensors.c b/drivers/hwmon/asus_wmi_sensors.c
index 9e935e34c998..4873edad4996 100644
--- a/drivers/hwmon/asus_wmi_sensors.c
+++ b/drivers/hwmon/asus_wmi_sensors.c
@@ -514,14 +514,16 @@ static int asus_wmi_configure_sensor_setup(struct device *dev,
int i, idx;
int err;
- temp_sensor = devm_kcalloc(dev, 1, sizeof(*temp_sensor), GFP_KERNEL);
+ temp_sensor = kzalloc(sizeof(*temp_sensor), GFP_KERNEL);
if (!temp_sensor)
return -ENOMEM;
for (i = 0; i < sensor_data->wmi.sensor_count; i++) {
err = asus_wmi_sensor_info(i, temp_sensor);
- if (err)
+ if (err) {
+ kfree(temp_sensor);
return err;
+ }
switch (temp_sensor->data_type) {
case TEMPERATURE_C:
@@ -536,6 +538,7 @@ static int asus_wmi_configure_sensor_setup(struct device *dev,
break;
}
}
+ kfree(temp_sensor);
if (nr_count[hwmon_temp])
nr_count[hwmon_chip]++, nr_types++;
--
2.34.1
