On Sun, 2021-05-02 at 19:00 +0100, Jonathan Cameron wrote:
> On Fri, 30 Apr 2021 18:24:16 +0300
> Ivan Mikhaylov <i.mikhaylov@xxxxxxxxx> wrote:
>
> > Add the possibility to run proximity sensor in periodic measurement
> > mode.
>
> Without an interrupt? Unusual and perhaps best left to userspace.
Do you mean without interrupt handler in driver for this particular interrupt?
If it's need to be added here, I can add it. In this patch I just added trigger
to enable/disable periodic measurement mode without interrupt handler.
>
> > + if (rc)
> > + return rc;
> > +
> > + /* Enable periodic measurement of proximity data. */
> > + cmd = VCNL_PS_EN | VCNL_PS_SELFTIMED_EN;
> > +
> > + /*
> > + * Enable interrupts on threshold, for proximity data by
> > + * default.
> > + */
> > + icr = VCNL_ICR_THRES_EN;
> > + } else {
> > + if (!vcnl3020_is_thr_enabled(data))
> > + return 0;
> > +
> > + cmd = 0;
> > + icr = 0;
> > + isr = 0;
> > + }
> > +
> > + rc = regmap_write(data->regmap, VCNL_COMMAND, cmd);
> > + if (rc)
> > + goto end;
> > +
> > + rc = regmap_write(data->regmap, VCNL_PS_ICR, icr);
> > + if (rc)
> > + goto end;
> > +
> > + if (!state)
> > + /* Clear interrupts */
>
> Given you don't seem to have an interrupt. I guess this is clearing
> a status flag?
Yes, it is clearing flag in interrupt status register.
>
> > + rc = regmap_write(data->regmap, VCNL_ISR, isr);
> > +
> > +end:
> > + if (state)
> > + iio_device_release_direct_mode(indio_dev);
>
