On 2/24/20 3:26 PM, Franz Forstmayr wrote:
Add documentation for INA260, power/current monitor with I2C interface.
Subject should match description here (this patch does not add support
for ina2xx).
Signed-off-by: Franz Forstmayr <forstmayr.franz@xxxxxxxxx>
---
Documentation/hwmon/ina2xx.rst | 19 ++++++++++++++++---
1 file changed, 16 insertions(+), 3 deletions(-)
diff --git a/Documentation/hwmon/ina2xx.rst b/Documentation/hwmon/ina2xx.rst
index 94b9a260c518..74267dd433dd 100644
--- a/Documentation/hwmon/ina2xx.rst
+++ b/Documentation/hwmon/ina2xx.rst
@@ -53,6 +53,16 @@ Supported chips:
http://www.ti.com/
+ * Texas Instruments INA260
+
+ Prefix: 'ina260'
+
+ Addresses: I2C 0x40 - 0x4f
+
+ Datasheet: Publicly available at the Texas Instruments website
+
+ http://www.ti.com/
+
Author: Lothar Felten <lothar.felten@xxxxxxxxx>
Description
@@ -72,14 +82,17 @@ INA230 and INA231 are high or low side current shunt and power monitors
with an I2C interface. The chips monitor both a shunt voltage drop and
bus supply voltage.
+INA260 is a high or low side current and power monitor with an integrated
+shunt and I2C interface.
+
The shunt value in micro-ohms can be set via platform data or device tree at
compile-time or via the shunt_resistor attribute in sysfs at run-time. Please
refer to the Documentation/devicetree/bindings/hwmon/ina2xx.txt for bindings
if the device tree is used.
-Additionally ina226 supports update_interval attribute as described in
-Documentation/hwmon/sysfs-interface.rst. Internally the interval is the sum of
-bus and shunt voltage conversion times multiplied by the averaging rate. We
+Additionally ina226 and ina260 supports update_interval attribute as described
s/supports/support/
+in Documentation/hwmon/sysfs-interface.rst. Internally the interval is the sum
+of bus and shunt voltage conversion times multiplied by the averaging rate. We
don't touch the conversion times and only modify the number of averages. The
lower limit of the update_interval is 2 ms, the upper limit is 2253 ms.
The actual programmed interval may vary from the desired value.
