The help text needs to spell out how the driver runs on a BMC, as it previously seemed to indicate it ran on a POWER processor. Signed-off-by: Eddie James <eajames@xxxxxxxxxxxxx> --- Changes since v1: fix Signed-off-by; git config got mixed up. drivers/hwmon/occ/Kconfig | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-) diff --git a/drivers/hwmon/occ/Kconfig b/drivers/hwmon/occ/Kconfig index 2a3869f..1658634 100644 --- a/drivers/hwmon/occ/Kconfig +++ b/drivers/hwmon/occ/Kconfig @@ -9,8 +9,10 @@ config SENSORS_OCC_P8_I2C select SENSORS_OCC help This option enables support for monitoring sensors provided by the - On-Chip Controller (OCC) on a POWER8 processor. Communications with - the OCC are established through I2C bus. + On-Chip Controller (OCC) on a POWER8 processor. However, this driver + can only run on a baseboard management controller (BMC) connected to + the P8, not the POWER processor itself. Communications with the OCC are + established through I2C bus. This driver can also be built as a module. If so, the module will be called occ-p8-hwmon. @@ -22,8 +24,10 @@ config SENSORS_OCC_P9_SBE select SENSORS_OCC help This option enables support for monitoring sensors provided by the - On-Chip Controller (OCC) on a POWER9 processor. Communications with - the OCC are established through SBE fifo on an FSI bus. + On-Chip Controller (OCC) on a POWER9 processor. However, this driver + can only run on a baseboard management controller (BMC) connected to + the P9, not the POWER processor itself. Communications with the OCC are + established through SBE fifo on an FSI bus. This driver can also be built as a module. If so, the module will be called occ-p9-hwmon. -- 2.7.4
