On Fri, Mar 22, 2019 at 09:24:01AM +0100, Stefan Wahren wrote:
> This adds the tachometer interrupt to the pwm-fan binding, which is
> necessary for RPM support.
>
> Signed-off-by: Stefan Wahren <stefan.wahren@xxxxxxxx>
> ---
> .../devicetree/bindings/hwmon/pwm-fan.txt | 22 +++++++++++++++++++++-
> 1 file changed, 21 insertions(+), 1 deletion(-)
>
> diff --git a/Documentation/devicetree/bindings/hwmon/pwm-fan.txt b/Documentation/devicetree/bindings/hwmon/pwm-fan.txt
> index 49ca5d8..722005f 100644
> --- a/Documentation/devicetree/bindings/hwmon/pwm-fan.txt
> +++ b/Documentation/devicetree/bindings/hwmon/pwm-fan.txt
> @@ -7,7 +7,16 @@ Required properties:
> which correspond to thermal cooling states
>
> Optional properties:
> -- fan-supply : phandle to the regulator that provides power to the fan
> +- fan-supply : phandle to the regulator that provides power to the fan
> +- interrupts : This contains a single interrupt specifier which
> + describes the tachometer output of the fan as an
> + interrupt source. The output signal must generate a
> + defined number of interrupts per fan revolution, which
> + require that it must be self resetting edge interrupts.
> + See interrupt-controller/interrupts.txt for the format.
> +- pulses-per-revolution : define the tachometer pulses per fan revolution as
> + an integer (default is 2 interrupts per revolution).
> + The value must be greater than zero.
>
> Example:
> fan0: pwm-fan {
> @@ -38,3 +47,14 @@ Example:
> };
> };
> };
> +
> +Example 2:
> + fan0: pwm-fan {
> + fan0: pwm-fan {
This line should go.
Otherwise,
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
> + compatible = "pwm-fan";
> + pwms = <&pwm 0 40000 0>;
> + fan-supply = <®_fan>;
> + interrupt-parent = <&gpio5>;
> + interrupts = <1 IRQ_TYPE_EDGE_FALLING>;
> + pulses-per-revolution = <2>;
> + };
> --
> 2.7.4
>
