On Fri, Sep 28, 2018 at 12:58:00PM -0700, Kun Yi wrote: > The ADM series of hotswap controllers support extending > the current measurement range by using a sensing resistor > value other than the typical 1 mOhm. For example, using a 0.5 mOhm > sensing resistor doubles the maximal current can be measured. > > Current driver assumes a shunt resistor value of 1 mOhm in calculation, > meaning for other resistor values, hwmon will report scaled > current/power measurements. This patch adds a device tree parameter so > that individual boards can configure its shunt resistor value. > > Signed-off-by: Kun Yi <kunyi@xxxxxxxxxx> > --- > .../devicetree/bindings/hwmon/adm1275.txt | 25 +++++++++++++++++++ This should be a separate patch. In particular, the subject doesn't really reflect that you are adding a new binding. Otherwise, the binding looks fine. > Documentation/hwmon/adm1275 | 3 +++ > drivers/hwmon/pmbus/adm1275.c | 15 +++++++++-- > 3 files changed, 41 insertions(+), 2 deletions(-) > create mode 100644 Documentation/devicetree/bindings/hwmon/adm1275.txt
